Sunny Health & Fitness SF-E3626 User manual

EZ STRIDE MOTORIZED
ELLIPTICAL
SF-E3626
USER MANUAL
IMPORTANT! Please retain owner’s manual for maintenance and
adjustment instructions. Your satisfaction is very important to us,PLEASE
DO NOT RETURN UNTIL YOU HAVE CONTACTED US:
[email protected] or 1- 877 - 90SUNNY (877-907-8669).

1
Thank you for purchasing the EZ Stride Motorized Elliptical. Please read the
operating instructions carefully before use, especially the safety precautions.
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be
followed, including the following:
Read all instructions before using this appliance.
DANGER –To reduce the risk of electric shock:
1. Always unplug this appliance from the electrical outlet immediately after
using and before cleaning.
WARNING –To reduce the risk of burns, fire, electric shock, or injury to
persons:
1. To reduce the risk of electric shock, this appliance has a polarized plug
(one blade is wider than the other). This plug will fit in a polarized outlet
only one way. If the plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install the proper outlet. Do
not change the plug in any way.
2. This product’s rated voltage is 110V, rated power is 25W, 30 min.
3. An appliance should never be left unattended when plugged in. Unplug
from outlet when not in use, and before putting on or taking off parts.
4. Do not stand on the elliptical, only use the elliptical while sitting.
5. Close supervision is necessary when this appliance is used by, on, or near
children, invalids, or disabled persons. Keep children away from appliance.
This is for adult use only.
6. Use this appliance only for its intended use as described in this manual. Do
not use attachments not recommended by the manufacturer.
7. Never operate this appliance if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into water.
Return the appliance to a service center for examination and repair.
8. Do not carry this appliance by supply cord or use cord as a handle.
9. Keep the cord away from the heated surfaces.
10.Never operate the appliance with the air openings blocked. Keep the air
openings free of lint, hair, and the like.
11.Never drop or insert any object into any opening.
12.Do not use outdoors.
13.Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
14.To disconnect, turn all controls off, then unplug from outlet.
15.To reduce the risk of injury, place the appliance on a flat, horizontal, and
stable surface. Do not place or use the appliance on a slippery surface.
16.To reduce the risk of injury, do not use the appliance with wet shoes, wet
feet, or socks.

2
17.To reduce the risk of injury, do not use the appliance if the surface is wet. If
the appliance surface becomes wet, dry the surface before using.
18.Turn off the power after each use. After using or before cleaning the
appliance, unplug the power supply from the outlet.
19.Do not cover while using, to avoid motor overheating and cause
malfunction or damage.
20.Be aware how you are feeling. If you feel uncomfortable or experience any
adverse symptoms, stop the using the appliance immediately.
21.Do not use the appliance if it is damaged or defective.
22.This appliance is not suitable for therapeutic use. Do not use with other
medical electronic equipment, such as pacemakers or EKG machines.
23.Do not use the appliance in wet or dusty environment. Do not use in humid
environment, such as bathroom.
24.Keep the appliance away from direct sunlight.
25.Do not operate the appliance with wet hands.
26.Do not allow water and other liquids to touch control switch.
27.Do not place the power cord under the appliance or any heavy object.
28.Do not wind the power cord around theappliance. That could damage the
power cord, cause electric shock or electrical fire.
29.If the power plug is loose, do not use theappliance.
30.If there is a power surge during use, stop using the appliance. Sudden
restoration of power could cause injury to you.
31.Consult your physician before use, especially if you have any medical
conditions such as diabetes.
SAVE THESE INSTRUCTIONS

3
1. Control panel
2. Pedal
4. Slideway
5. Non-slip mat
3.Handle

4
CONTROL PANEL FEATURES
WARNING:
Only use the elliptical while sitting. Do not stand on the elliptical.
Keep the elliptical on the non-slip mat (included) when using.
1
Power
Turns elliptical ON and OFF
Power is
ON
(Standby)
2
Manual Exercise
Selects Manual Exercise setting
Changes resistance from LO to MI to HI
3
Auto
Exercise
Selects Auto Exercise setting
Changes speed from LO to MI to HI
4
Mode
Selects Mode setting
Changes mode from ACTIVE to
MODERATE to LIGHT
5
Pedometer
Display
Displays number of steps.
6
Forward
Changes direction to forward
Backward
Changes direction to backward
Power is
OFF
7
Resistance
Changes resistance when the power is
off or elliptical is unplugged

5
OPERATING INSTRUCTIONS
1. Plug in the elliptical.
2. Press Power button to turn on the power.
3. Select one of the following modes:
AUTO EXERCISE
Press Auto Exercise. The pedals will rotate forward starting at LO speed.
Press Auto Exercise to increase speed to MI.
Press Auto Exercise to increase speed to HI.
Press Forward or Backward to change the direction.
MODE
Press Mode. The pedals will rotate at ACTIVE mode and alternate
between forward and backward.
Press Mode to change mode to MODERATE.
Press Mode to change mode to LIGHT.
Press Forward or Backward to change the direction.
MANUAL EXERCISE
Press Manual Exercise. Resistance starts at LO. You can start pedaling.
Press Manual Exercise to increase resistance to MI.
Press Manual Exercise to increase resistance to HI.
Press Forward or Backward to change the direction.
4. Press Power button to turn the elliptical off.
OPERATING INSTRUCTIONS WHEN
POWER IS OFF OR NOT PLUGGED IN
You can use the elliptical when it is not plugged in or when the power is off.
You can pedal forward or backward.
Use the resistance switch to change the resistance.
Setting 1 is low resistance.
Move switch to setting 2 to increase resistance.
When the power is off or not plugged in, the pedometer will not display the
number of rotations.

6
FEATURES
AUTO SHUT-OFF
The elliptical automatically shuts off after 30 minutes. When there is 1 minute
remaining, the elliptical will beep. Press Auto Exercise, Manual Exercise or
Mode button to restart the timer at 30 minutes and continue exercising.
PEDOMETER
The display will count steps. For each rotation, the display will increase in
increments of 2.After the first rotation, it will display 2, then 4, then 6 and so on.
Display range is 0-9999. Pedometer starts at zero each time you turn on the
elliptical.
DIRECTION CORRECTION
Do not pedal in the opposite direction as the setting you choose.
During Manual Exercise orAuto Exercise, if you pedal in the opposite direction
of the setting, the elliptical will beep, then change to the direction you are
pedaling.
If you repeatedly pedal in the opposite direction as the setting, the elliptical will
stop and you will get an error code.
MOVING THE PRODUCT
Always use the built-in handle to carry or move the elliptical.
PRODUCT CARE
Storage
When not in use, place the product into the box and place in a dry, ventilated,
cool area.
Do not twist the power cord.
Do not place product in direct sunlight or heat. Do not store where there is high
humidity, such as bathrooms.
Cleaning
Before cleaning, make sure to turn power off and unplug the power cord. Use a
dry cloth to clean the surface of the product.
Do not use corrosive cleaning agents to clean the product.

7
TROUBLESHOOTING
If you have problems when using this product, refer to the following tips and
possible solutions.
POSSIBLE CAUSE
SOLUTION
Product does
not turn on
Not powered
Power switch is not
turned on
1. Make sure power cord is
plugged in
2. Turn on the switch
Product
suddenly
stops
operating
Power failure
Timer exceeded 30
minutes.
Continuous use
time is too long,
overheat protection
1. Check the power cord is
connected
2. Press the Power button to turn
the machine on
3. Let the product cool down, then
turn power back on
E1 error code
1. Wait 15 seconds, and elliptical
will shut off.
2. Turn the machine back on, and
the error code will clear.
3. Or you can turn the elliptical off
and on, and the error code will
clear.
Version 1.2