SuperATV WLK-001 User manual

Windshield Light Kit
INSTALLATION INSTRUCTIONS
© 2015 SuperATV.com®. All Rights Reserved. Rev IN-WLK-001 12/16/2016
Read instructions and view illustrations before beginning.
Need help with your installation?
1-812-574-7777
[e-mail] www.superatv.com
8:00am - 9:00pm EST M-Th
8:00am - 7:00pm EST Friday
9:00am - 2:00pm EST Saturday
SuperATV recommends installing to half windshields only.
Liability Statement
SuperATV’s® products are designed to best t user’s ATV/UTV under stock
conditions. Adding, modifying, or fabricating any factory or aftermarket parts will
void any warranty provided by SuperATV®and is not recommended. SuperATV’s®
products could interfere with other aftermarket accessories. If user has aftermarket
products on machine, contact SuperATV® to verify that they will work together.
Although SuperATV® has thousands of satised customers, user should be aware
that installing lift kits, long travel, or suspension kits, tires, etc. will change the ride
of machine and may increase maintenance and part wear. Operating any off-road
machine while, or after, consuming alcohol and/or drugs increases risk of bodily
harm or death. No warranty or representation is made as to this product’s ability to
protect user from severe injury or death. SuperATV®urges operators and occupants
to wear a helmet and appropriate riding gear at all times.
By purchasing and installing SuperATV®products, user agrees that should damages
occur, SuperATV®will not be held responsible for loss of time, use, labor fees,
replacement parts, or freight charges. SuperATV®, nor any 3rd party, will not be held
responsible for any direct, indirect, incidental, special, or consequential damages
that result from any product purchased from SuperATV®. The total liability of seller to
user for all damages, losses, and causes of action, if any, shall not exceed the total
purchase price paid for the product that gave rise to the claim.
SuperATV®will warranty only parts provided by SuperATV®. Any damage or
problems with OEM housings, bearings, seals, or other manufacturers’ products will
not be covered by SuperATV®. SuperATV®parts and products are not warrantied if
item was not installed properly, misused, or modied.
Kit Contents
Gasket
LED Strip
Switch
Wiring and Connectors
2753 Michigan Road • Madison, Indiana 47250 • 812-574-7777
Thank You
For Choosing

IN-WLK-001 2
If applicable, cut LED Strip to desired length.
Cut LED Strip here.
LED Strip
- Insert LED Strip into Channel. LED’s
will face towards 2 “Ribs” in Channel.
Ribs
Channel

IN-WLK-001 3
- Gently use Wheel to push LED Strip further into Channel.
Wheel
- LED Strip is in correction position inside Channel.

IN-WLK-001 4
- Install Channel to Windshield.

IN-WLK-001 5
to LED Strip
to Battery (+) POS;
Red wire
to Battery (-) NEG;
Black wire
LED Strip; (-) NEG
Red w/Black Stripe wire
Green is (-) NEG to LED Strip;
Red w/Black stripe wire
Switch
2
8
3
Yellow is (+) POS to LED Strip;
Red wire
LED Strip; (+) POS
Red wire From Switch
Switch Wiring