Techni Mobili RTA-2334 User manual

MODEL RTA - 2334
Thanks for purchasing one of our products.
Please read carefully the assembly instructions before the installation.
Please save this manual for future reference.
ASSEMBLY INSTRUCTIONS
MODEL RTA - 2334

RTA-2334

Left Structure Right Structure
Back Tube
Front Tube
Studs Left Panel Right Panel Back Panel
Bottom Panel Small Front Panel Top Panel Sliders
Connecting Tube Drawer Connect Top Drawer Front
Panel
Bottom Drawer Front
Panel
X4
X2 X4
RTA-2334 P.3

6
8
3
Φ18 MM
Drawer Left Panel Drawer Right Panel Drawer Bottom Panel Drawer Back Panel
Connect Panel Table Top
Wire Base USB Hub
RTA-2334 P.4
X2 X2 X2 X2

P.5
RTA-2334

30mm
P.6
RTA-2334

Use screws B to assemble the Drawer Connects (14) to the
Drawer Left and Right Panels (17 & 18).
P.7
RTA-2334
Use screws D to assemble the Drawer
Connects (14) to the Top Drawer Front
Panel (15) and Bottom Drawer Front
Panel (16).
Slide in the Drawer Bottom Panel (19).

RTA-2334
Use screws C to assemble the Drawer Back
Panels (20) to the Drawer Left and Right
Panels (17 & 18).
Grab the 2 sets of the Drawer Sliders (12) and separate the flat
ones from the “L” shaped ones. Place the drawer upside-
down as shown and use screws B to assemble the “L” shaped
Sliders to the Drawer Left & Right Panels (17 & 18) as shown.
IMPORTANT: REFER TO THE DRAWINGS FOR THE CORRECT
POSITION OF THE SLIDERS. If they get installed incorrectly,
the drawers will raise 1" with a gap at the bottom and the top
drawer will not close!
Insert the Studs (5) into the Left and
Right Structure (1 &2)..
P.8
RTA-2334

4PCS
Use screws E to assemble the Back
Tube (3) and Front Tube (4) to the Left
and Right Structure (1 & 2).
Please pay attention to the orientation
of the tubes and their holes as shown.
Grab the Flat Sliders (12) and use screws B to assemble them
to the Left & Right Panels (6 & 7) as shown.
The wheel on the sliders go facing to the FRONT and the screw
goes on the hole after the wheel as shown.
P.9
RTA-2334

P.10
RTA-2334
First screw bolts A to the Left and Right Panel (6 & 7) , but make
sure to use the correct holes that are the ones closer to the edges.
Then assemble the Back Panel, Bottom Panel and Small Front
Panel (8, 9 & 10) as shown and as explained in page 5.
First screw bolts A to the Top Panel (11), then assemble
this panel to the Left and Right Panel (6 & 7) as shown
and as explained in page 5.
Use screws F & I to assemble the Connecting Tubes (13)
to the Top Panel (11).

P.11
RTA-2334
Use screws F to assemble the Connecting Tubes (13)
to the Back Tube (3) and Front Tube (4).
Use screws F & I to assemble the Left Panel (6) to the
Left Structure (1).
Use screws G, H & I to assemble the Connect Panel (21) to
the Right Panel (7) and Right Structure (2).
Note: Washers I are used on the left side only.
Use screws E & J to assemble the Wire Base (23) to
the Back Tube (3).

1PC
1PC
KΦ18 MM
P.12
RTA-2334
Use screws D, G & K to assemble the Table Top (22).
Insert the USB Hub (24) to the Table Top (22).
Tighten any and all screws.
Insert the drawers into the cabinet,
starting with the bottom drawer.
You might have to insert it at a
downward tilted angle.

English
- DO NOT EXPOSE THE SURFACES TO DIRECT SUNLIGHT OR EXTREME
ENVIRONMENTAL CONDITIONS. ANY DAMAGE RESULTING FROM SUCH
EXPOSURE IS NOT COVERED BY THE PRODUCT’S WARRANTY.
- THE PREFERABLE METHOD TO CLEAN THE SURFACES IS TO WIPE THEM
USING A SOFT CLOTH DAMPENED WITH A SOLUTION SOAP AND WATER,
THEN DRY WITH A CLEAN TOWEL.
- DO NOT SPRAY SOLVENTS OR CLEANING AGENTS DIRECTLY OVER THE
SURFACES, STRUCTURAL TUBES OR METAL PARTS.
- DO NOT LEAN, SEAT OR STAND OVER THE UNIT.
- DO NOT ALLOW CHILDREN TO PLAY OVER/UNDER THE UNIT, NOR ALLOW
THEM TO REACH INSIDE ANY COMPARTMENTS WITHOUT THE SUPERVISION
OF AN ADULT.
- BEFORE MOVING OR TRANSPORTING THE UNIT, MAKE SURE THAT:
ALL HEAVY OBJECTS OR THAT MIGHT FELL OFF ARE REMOVED FROM
THE UNIT.
IF THE UNIT ARE ON CASTERS (WHEELS), MAKE SURE THAT ALL ARE
UNLOCKED.
THE UNIT MUST BE HANDLED BY AT LEAST 2 PERSONS.
WHEN LIFTING THE UNIT, USE BOTH OF YOUR HANDS, AND BEND YOUR
KNEES. REMEMBER TO ALWAYS LIFT WITH YOUR LEGS, NOT YOUR BACK.
- IN CASE OF DAMAGE TO ANY PARTS, NOTIFY THE VENDOR AS SOON AS
POSSIBLE.
- IN CASE OF GLASS BREAKAGE (IF THE UNIT HAS A GLASS TABLE TOP OR
PARTS MADE OF GLASS) DO NOT HANDLE THE BROKEN GLASS WITH YOUR
BEAR HANDS, AND CONTACT THE VENDOR IMMEDIATELY. DO NOT ALLOW
CHILDREN NEAR THE BROKEN GLASS.
CARE AND MAINTENANCE