teko Astra-322 User manual

Astra-322
Electro-Contact Panic Button
User Instructions
Sales, Warranty Service and Technical Sup-
port:
TEKO-TD
Prospekt Pobedy str. 19
420138 Kazan, Russia
[phone]
[email protected]z www.teko.biz www.teko.biz/en
Made in Russia
Rev. 322-v1_0_instr_EN
1 FUNCTION
The detector is untended for manually switching
on the alarm signal by pressing the button and
transferring the alarm signal to control panel or
notification transmission system.
2 SPECIFICATION
Power supply voltage, V:
- first range....................……………from 9 to 16
- second range..............................from 16 to 27
Current consumption, mA, max:
- in standby mode .......................................0,15
- in "Alarm" mode ..........................................20
Overall dimensions, mm.....................86×40×19
Operating Conditions
Temperature range, °С............from - 10 to + 50
Relative air humidity, % ........up to 95 at + 25 °С
Withoutmoisture condensation
3 DELIVERY SET
Delivery set includes: unlock key –2 pcs., dow-
el –2 pcs., screw –2 pcs.
4 OPERATING MODE
Operating mode
Plug
name
Jumper
position
First
voltage range
Second
voltage range
F1
The detector generates an alarm signal once
the detector button is pressed.
An “Alarm” state is fixed by electronic circuit of
the detector on the basis of electronic lock.
Return the detector to standby status is
achieved by turning the key or turning off the
detector for at least 2 seconds.
5 SELECTING INSTALLATION PLACE
The detector shall be mounted in a concealed,
discreet location for prompt and inconspicuous
use.
6 INSTALLATION PROCEDURE
1) Remove cover
with PCB fixed
inside it
2) Press out
blanks from
mounting and wire
insertion holes on
the base
3) Perform wiring
(see sec.7)
4) Replace cover
5) Perform detector operability test (see sec.8)
7 WIRING
Perform wiring to detector`s terminals in
accordance with control panel operating manual.

Zone, GND –terminals for detector connection
to alarm loop.
WARNING! Power supply voltage to alarm
loop should be at least 9 V for the first voltage
range and at least 16 V for the second voltage
range.
8 OPERABILITY TEST
1) Press the
button and hold
down at least 1
sec.
LED lights up
constantly.
2) To restore the
detector to the
standby status,
turn the key.
9 WARRANTY
The operation warranty period is 2 years from the date
of operation start-up but no longer than 2 years 6
months from the date of manufacturing subject to the
requirements of Operating Manual.