Travis Industries 95100055 User manual

DVL Universal No Panel Face
Small 95100055 Large 95100056
Page 1 of 3 17601596 - 2/1/10 © Travis Industries, Inc.
Compatibility:
• DVL GSR
• 33 DVI
Sizing
Packing List:
• Face (Backing Plate)
• (8) # 8 Keps Nuts
• Left and Right Mounting Brackets
• Surround Panel Mounting Brackets
• (8) #10 Keps Nuts
Width Height
Small 40” 27”
Large 44” 33-1/2”
Installation of the Rheostat and On/Off Switch (33 DVI Only)
When using this face you may install the on/off switch on the face (see instructions below) or on the control
panel (see manual). The rheostat must be installed on the control panel. See the directions below for details.
WARNING: Make sure to unplug the heater before installing the rheostat.
Make sure the wires leading to the on/off switch are firmly attached (they attach to the top and bottom posts
on either side of the switch -it does not matter which wire is on top). Route the on/off switch to the slot on the
upper right of the face (you will need to remove the lock-tie on the wiring harness). Remove the knock-out
and slide the switch into the rectangular slot until it locks into place.
Upper Right of Face
AA
AA
AA
AA
AA
AA
AA
Remove the knob and nut from the rheostat. Insert the shaft on the rheostat through the circular hole on the
control panel and secure with the nut. Replace the knob.
Control Panel
(next to gas control valve)

DVL Universal No Panel Face
Small 95100055 Large 95100056
Page 2 of 3 17601596 - 2/1/10 © Travis Industries, Inc.
Face Installation
NOTE: On the “No Panel Face”remove any lock ties used to secure the access door.
Attach the face mounting
brackets to the back of the
face with the eight included
nuts.
Tilt the face back and insert the bottom brackets
into the lower slots until they lock in place.
Lift and rotate the face forward until the
top brackets lock into the upper slots.
b
a
Optional Knock-Out
for Power Cord
(both sides)

DVL Universal No Panel Face
Small 95100055 Large 95100056
Page 3 of 3 17601596 - 2/1/10 © Travis Industries, Inc.
Using Surround Panels With this Face
The included mounting brackets may be attached to the insert to allow installation of the surround panels behind the
face. To better access the brackets, remove the glass frame from the insert (see the manual for details).
NOTE: These brackets offset the fireplace insert 1-1/8”to the front. This makes the insert protrude farther onto the
hearth and moves the flue towards the front by 1-1/8”
Attach the brackets to the panels (use the screws
included with the panels). The brackets then attach to
the insert (use the nuts included with the face).
a
b
NOTE: The lower
bracket is larger.