Travis Industries shield 6015 User manual

6015 Black Glass Firebacks
Sku# – 96100980
Page 1 of 3 17602092 - 4/20/22 Travis Industries, Inc.
Packing List
(1) Rear Glass Firebacks
(2) Side Glass Firebacks
(4) Long Glass Spacers
(4) Short Glass Spacers
Installation
GLASS FIREBACK WARNINGS
HANDLING THE FIREBACKS: The glass firebacks are fragile – especially the edges. Take care to prevent
contacting/scraping the glass against metal or rough surfaces. You may wish to lay out a blanket during
installation in case you need to set the firebacks down.
We recommend the use of gloves and safety glasses during the installation of the glass firebacks.
CLEANING
These firebacks require periodic cleaning. Do not use ammonia-based cleaners (this may cloud the glass). We
recommend ammonia-free glass cleaner (i.e. vinegar and water) to clean the fireback.
1 Access the firebox (see appliance manual for details).
2 Remove the (2) rear and the (2) side fireback clips from the firebox ceiling (1/4” nut driver). The clips
have a “keyhole” so loosen the screws but do not remove them. Slide the clips away from the firebox wall
and lower them over the screw heads. Set the clips aside for reinstallation. Leave the screws loose, they
will be tightened in a later step.
1/4" Nutdriver

6015 Black Glass Firebacks
Sku# – 96100980
Page 2 of 3 17602092 - 4/20/22 Travis Industries, Inc.
3 Prepare the (8) spacers by bending the tabs (2 per clip) up approximately 90° (see below).
4 Install the (2) clips on each of the side firebacks (top and bottom) and (4) clips on the rear fireback. The
longer spacers are used on the rear fireback pieces and the shorter spacers are for the sides. The glass
slides into the area between the tab bent up in the previous step and the front edge of the spacer.
The glass rests
in this area
Back of spacer (rests
against firebox wall
Front of spacer

6015 Black Glass Firebacks
Sku# – 96100980
Page 3 of 3 17602092 - 4/20/22 Travis Industries, Inc.
5 Install the rear fireback. Insert one end of the fireback through the firebox opening. Carefully move it
deeper into the firebox until the opposite end of the fireback clears the opening. Once the entire fireback
is in the firebox, maneuver the fireback parallel to the back of the firebox and center it against the back
wall.
WARNING: Make sure not to damage the edges of the glass as you maneuver it through the fireplace
opening.
6 Secure the fireback panel in place using the fireback clips removed in step 1. Install the clip over the
screw head in the firebox. Slide the clip up against the glass fireback until it holds the fireback against the
firebox wall. Tighten the screw to secure the clip in place (see below).
7 Install the side firebacks in the same manner.
8 Restore the fireplace to the correct configuration.
1/4" Nutdriver