Trinity PROFESSIONAL 41 HLRT24111 User manual

OWNERʼS MANUAL
PROFESSIONAL 41”STAINLESS STEEL
ELEVEN DRAWER TOOL CHEST
Model # HLRT24111

In using your TRINITY Tool Chest, please
observe the following safety precautions:
TM
SAFETY PRECAUTIONS
1
© 2008 TRINITY - 800.985.5506

Your TRINITY Professional 41”Stainless Steel Eleven Drawer Tool Chest
should include the following parts. Before assembling, unpack the carton
and lay out all of the parts described below. If you are missing any parts,
need assistance with assembly or have questions, please contact TRINITY
Customer Service at 800.985.5506 or at [e-mail].
Parts can also be requested online at our customer center at
www.TRINITYii.com.
PARTS LIST
2
© 2008 TRINITY - 800.985.5506
SIDE HANDLE SCREWS (12) SIDE HANDLES (2) LINERS (7)
ABC
KEYS (2)
D
TOP CHEST

SIDE HANDLE SCREWS (12) SIDE HANDLES (2) SWIVEL CASTER W/O LOCK (2)
E F G
SWIVEL CASTER W/LOCK (2) REAR BRACES (2) REAR BRACE SCREWS (8)
HI J
SWIVEL CASTER SCREWS (16) KEYS (2) LINERS (6)
KLM
BOTTOM CHEST
PARTS LIST
3
© 2008 TRINITY - 800.985.5506

Be sure to assemble the SIDE HANDLES
(B,F) on both the Top and Bottom Chests to
make it easier to move your Tool Chest
4
© 2008 TRINITY - 800.985.5506
ASSEMBLY INSTRUCTIONS
STEP 1: INSTALLING SIDE HANDLES
Position the SIDE HANDLES (B,F) over
the precut holes and attach them using the
(mid-sized) SIDE HANDLE SCREWS
(A,E). Tighten securely.
STEP 2: INSTALLING SWIVEL CASTERS
Carefully lay the Bottom Chest on its back. Position the two SWIVEL
CASTERS W/O LOCKS (G) on the right side. Position the two SWIVEL
CASTERS W/LOCKS (H) on the left side. Insert the (large-sized) SWIVEL
CASTER SCREWS (K) through the SWIVEL CASTERS (G,H), and then
into the bottom of the Chest. Tighten securely.

Be sure to assemble the REAR BRACES (I) to secure the Top Chest to the
Bottom Chest.
5
© 2008 TRINITY - 800.985.5506
ASSEMBLY INSTRUCTIONS
STEP 3: INSTALLING REAR BRACES
STEP 4: INSTALLING DRAWER LINERS
Simply Place the LINERS (C,M) inside the top compartment and inside of
each drawer
Position the REAR BRACES (I) over the precut holes at the back edge
where the two Chests adjoin, and attach the REAR BRACES (I) using the
(small-sized) REAR BRACE SCREWS (J). Tighten securely.

6
© 2008 TRINITY - 800.985.5506
USAGE INSTRUCTIONS
DRAWER REMOVAL
Pull the drawer out so that it is almost fully extended. Push the back release
lever DOWN on the RIGHT-hand side. Pull the black release lever UP on the
LEFT-hand side. While holding the levers as instructed, pull the drawer
forward until released from the slides attached to the Tool Chest (“Tool Chest
Slides”). Note: The slides attached to the drawer (“Drawer Slides”) are an
integral part of the drawer and must be removed along with the drawer itself.
DRAWER REPLACEMENT
Extend the Tool Chest Slides for the drawer to be replaced. Insert the
brackets on each side of the Drawer Slides into the corresponding slots on
the Tool Chest Slides, making sure they are properly positioned. Once the
brackets are inserted into the slots, completely close the drawer to set all
slides in their proper positions.
PULL UP PUSH DOWN

TRINITY Customer Service provides the following replacement parts:
SERVICE PARTS LIST
7
© 2008 TRINITY - 800.985.5506
NOTE: Replacement keys may be ordered using the code shown on the face of
the lock. The Top and Bottom Chests may have different key codes.
1) HLRT-SH: Side Handle
2) HLRT-GL: Gas Lift
3) HLRT-LINER: Drawer Liner
4) HLRT-SLTC: Tool Chest Slide
5) HLRT-SLDR: Drawer Slide
6) HLRT-MDRS: Medium Drawer
(w/ Front Face Panel)
7) HLRT-LDRAH: Medium Aluminum
Drawer Handle
8) HLRT-LCDRS3: Large Complete Set
9) HLRT-KEY: Keys
10) HLRT-LOCK: Lock
1
12
11
7
5
9
5
6
8
4
3 2
11) HLRT-SCDRS6: Short
Complete Drawer 6”
Set
• HLRT-SCDRS3: Short
Complete Drawer 3”
Set
10

TRINITY Customer Service provides the following replacement parts:
SERVICE PARTS LIST
8
© 2008 TRINITY - 800.985.5506
1) HLRT-SH: Side Handle
2) HLRT-BRACE: Rear Brace
3) HLRT-LOCK: Lock
4) HLRT-KEY: Keys
5) HLRT-SLTC: Tool Chest Slide
6) HLRT-SLDR: Drawer Slide
7) HLRT-LDR: Large Drawer
(w/o Front Face Panel)
8) HLRT-LDR: Large Drawer
(w/Front Face Panel)
9) HLRT-LDRAH: Large Aluminum
Drawer Handle
10) HLRT-LCDRS6: Large
Complete Set 6”Deep
11) HLRT-LCDRS3: Large
Complete Set 3”Deep
12) HLRT-LINER: Drawer Liner
13) HLRT-LCDRS9: Large
Complete Set 9”Deep
14) HLRT-SCWOL: Swivel
Caster w/o Lock
15) HLRT-SCWL: Swivel
Caster w/Lock
1
2 3 4
14
6
5
15
13
12
10
9
8
11
7

TRINITY PROFESSIONAL 41”STAINLESS STEEL
ELEVEN DRAWER TOOL CHEST
Model # HLRT24111
TRINITY warrants to the original consumer purchaser (“Purchaser”) of the TRINITY Professional 41”
Stainless Steel Eleven Drawer Tool Chest (“Product”) that each Product shall be free from defects in
workmanship and materials for a period of 1 year from the date of original purchase. TRINITYʼs
obligation under this warranty shall be limited to repair or replacement of, or adequate compensation
for, the Product, at the option of TRINITY, during the warranty period. TRINITYʼs liability shall not
extend beyond repair or replacement, or the cost equivalent thereto.
This warranty excludes normal wear and tear of the Product and its parts or components, and damage
arising from any of the following: negligent use or misuse of the Product, use contrary to this Ownerʼs
Manual, or alteration by any one other than TRINITY. This warranty exclusion includes purchasing
open-box and returned items. The warranty period of 1 year shall not be extended or renewed by the
repair or replacement of, or compensation for, the Product.
If your Product is defective or otherwise requires service or parts, please first call TRINITY Customer
Service toll-free at 800.985.5506, between 8:00 a.m. to 5:00 p.m., PST, or send an e-mail to
[e-mail]. You can also request assistance online at our customer center at
www.TRINITYii.com. TRINITY commits to using its very best efforts to honor this warranty, and repair,
replace or compensate you for your Product through your original place of purchase. Please tell us
which model you purchased, the date of purchase, and the problem with your Product. A copy of your
original purchase receipt and a completed copy of your product registration must accompany your
service request.
LIMITATION OF REMEDIES AND LIABILITY
TRINITY shall not be liable for any incidental or consequential damages for breach of any express or
implied warranty on its Product. Except to the extent prohibited by applicable law, any implied warranty
or merchantability or fitness for a particular purpose on this Product shall be limited to the duration of
the above warranty. Neither TRINITY nor anyone else who has been involved in the creation,
production, or delivery of the Product shall be liable for damages of any type, including but not limited
to any lost profits, lost savings, loss of anticipated benefits, or other incidental or consequential
damages which may arise out of the purchase, use, or inability to use the Product, whether arising out
of contract, negligence, strict tort, or under any warranty, or otherwise, even if you have been advised
of the possibility of such damage or any other claim by any other party. TRINITYʼs liability for any
breach of warranty shall be limited to repair or replacement of the defective part or parts as described
above. Some states do not allow the exclusion or limitation of incidental or consequential damages, so
the above limitation or exclusion may not apply to you. The above warranty gives you specific legal
rights, and you may have other rights which vary from state to state.
LIMITED WARRANTY
9
© 2008 TRINITY - 800.985.5506

Thank you for purchasing a TRINITY Professional 41”Stainless Steel Eleven Drawer Tool
Chest. In order to register your product to receive streamlined customer service, please fill out
the following Product Registration Form and (1) fax the form to FAX [phone] (2)
complete the Product Registration Form online at www.TRINITYii.com (3) or scan and email
the form to [e-mail]. Include a copy of your original receipt with your
submission.
First Name: Last Name:
Address:
City: State: Zip Code:
Email Address: Phone:
Product Model #: Purchase Date: / /
Location of Purchase:
Please rate the importance of each feature (1=least important; 10=most important)
Quality Price Size/Capacity Appearance Other
What other brands did you seriously consider before making this purchase?
Craftsman Snap On Waterloo
Matco Other Did not consider other brands
How did you hear about our product?
Magazine Ad Catalog Salesperson Word of Mouth
Internet Store Display Other
Marital Status: Single Married
Household Income: Below $50,000 $50,000-$150,000 $150,000+
Education: High School College Graduate School
Primary Residence: Own Rent
Comments/Suggestions:
PRODUCT REGISTRATION
10
© 2008 TRINITY - 800.985.5506

TRINITY Customer Service
TEL: [phone]
FAX: [phone]
EMAIL: [e-mail]
Monday through Friday
8:00 AM – 5:00 PM (PST)
www.TRINITYii.com
QUESTIONS? NEED PARTS?
WE ARE HERE TO HELP!
To receive your replacement part, please fax or email
your receipt and product registration along with your
name, address and a brief description of your problem to:
CONTACT US