Turnstone Elan TS52077 User manual

Page 1 of 3
939503211 Rev B
Élan™Corner Bridge R
©2001 Steelcase Inc.
Grand Rapids, MI 49501 U.S.A.
Printed in U.S.A.
TS52077
support brackets
screws
modesty panels
corner bridge
support straps
1. unpack the components. Unpack the parts and lay them
out on a carpeted surface (to avoid scratches). Make sure you
have all the items shown below. Note:the corner bridge must
be supported by two Élan Table Desks.
2. assemble table desks. Follow the Élan Table Desk user
guide steps 1-6. (Note: be sure to use one end leg and one mid
leg for each desk.)
3. attach support brackets. Before fliping desks, attach the
support brackets and straps to the desks in the predrilled holes
as shown. Using two people, flip desks over .
4. align desks. Place desks in approximate position and align
by setting the corner worksurface on to support brackets. Once
aligned, remove cor ner worksurface.
mid legs
3
4

step 7
Page 2 of 3
939503211 Rev B
5. attach the corner bridge, mid leg and
modesty panel. Slide the hooks on the ends of
the modesty panel into the slots on both legs.
Repeat with other modesty panel. Note:The
“over bent” hooks go into the center mid leg.
6. attach the corner worksurface. Place the
corner worksurface onto the brackets. Align
and attach with the screws provided.
7. attach the modesty panel to the corner
worksurface. Once the corner worksurface is
secure, attach the modesty panels to the
underside using pilot holes and screws
provided.
8. adjust glides as needed. Move the unit
into place and adjust the glides to compensate
for uneven floors.
That's it!
mid legmid legmid legmid leg
5a
6
5b

Page 3 of 3
939503211 Rev B
Maintenance
Furniture Protection
Desk pads and coasters should be used to help
protect the surface against dents, scratches,
moisture and hot or cold liquids. Objects should be
lifted, not pulled or pushed across the surface, to
avoid scratching the furniture. Felt or leather pads
should be used on the bottom of office equipment or
accessories.
Cleaning Melamine Surfaces
For all laminate tops, painted and plated metals, and
plastics: Wiping with a damp cloth will remove
general soiling and water-borne stains. If needed,
use a hard-surface, all purpose cleaner. Some oil-
borne stains may require the use of a dry-cleaning
fluid or naphtha. To fill scratches in wood grain
laminate tops, use an oak, walnut, or mahogany
putty stick (available at paint supply and hardware
stores).
Cleaning Hardware
Metal finishes should be cleaned with water and/or a
non-abrasive cleaner. Household cleaners for wood
may be used, but usually warm water is sufficient.
Wipe the hardware with a damp, soft cloth, or a cloth
to which you have sparingly applied the cleaner.
Wipe dry with a clean cloth.
Moving Furniture
When moving desks short distances, make sure that
the legs are secured to the body of the unit. Move
the unit by picking it up and carefully placing it into
the new position. The desk should not be dragged
on the floor. When moving long distances, legs
should be detached from the desk body.