Turnstone Wow TS325 Series User manual

Page 1 of 3
TS325A Rev B
TS325A
Wow
R
©2001 Steelcase Inc.
Grand Rapids, MI 49501 U.S.A.
Printed in U.S.A.
1. Insert the shafts of the casters
into their corresponding sockets
of the base. Push in firmly.
Stand the base upright.
2.Insert cylinder into base
With base resting on floor, insert
cylinder as shown.
fixed arm
desk chair
TS325-02
armless
desk chair
TS325-01

Page 2 of 3
TS325A Rev B
3.  Assemble cylinder cover
Slide cylinder (A) up through cylinder (B)
(see fig 1). With cylinder (A) engaged with
cylinder (B), slide cylinder (C) down over
cylinders (A and B) (see fig 2). Refer to
fig. 3 for completed assembly.
5.  Attach seat to cylinder
Line up hole over cylinder, and
place seat down. By grabbing
the seat, firmly push the entire
chair towards the floor to properly
lock the taper on the cylinder
into the seat and the base.
6.  Remove the knob from the control (Fig. 1). Push bottom end of the upright into the
channel at the back of the control plate (Fig. 2) and tighten the seat hand wheel knob, as
shown (Fig. 3).
4. Place cover over the cylinder in base.
fig. 1 fig. 2 fig. 3
A
BA
B
C
A
B
C
A
B
C
Fig. 1 Fig. 2 Fig. 3

Page 3 of 3
TS325A Rev B
Attachment of arms
Fig. 1 Fig. 2