Turnstone Surprise TS305 User manual

B
Page 1 of 3
TS305 Rev D
TS305
Surprise™
R
©2001 Steelcase Inc.
Grand Rapids, MI 49501 U.S.A.
Printed in U.S.A.
Task Chair Stool Desk
Chair
1. Insert cylinder into base
With base resting on floor, insert
cylinder as shown.
2. Assemble cylinder cover
Slide cylinder (A) up through cylinder (B)
(see fig 1). With cylinder (A) engaged with
cylinder (B), slide cylinder (C) down over
cylinders (A and B) (see fig 2). Refer to
fig. 3 for completed assembly.
fig. 1
BC
A
A
A
B
B
C
fig. 2 fig. 3

Page 2 of 3
TS305 Rev D
3. Place cover over the cylinder (see fig. 1).
For stools with a foot ring, insert the gas cylinder
into the foot ring and tighten (see fig 2). Place
cover over the cylinder (see fig. 3).
4. Attach seat to cylinder
Line up hole over cylinder, and place seat down. By
grabbing the seat, firmly push the entire chair towards
the floor to properly lock the tapers on the cylinder
into the seat and the base.
Fig. 1
A
B
C
Fig. 3
Fig. 2
A
B
C

Page 3 of 3
TS305 Rev D
5.  Attach back to chair
(refer to your model number
chair below)
For TS305-01, TS305-04,
TS305-05, TS305-06, TS305-07,
TS305-08: Unscrew the bolt,
slide metal base of back through
slit of rear of seat as shown.
For TS305-02, TS305-09:
Remove locking pin from bottom
of seat (near the control). Place
metal upright through slit at rear
of seat as shown. Install plastic
pin to keep the upright from
backing out of control.
TS305-01
TS305-04
TS305-05
TS305-06
TS305-02
TS305-09
TS305-07
TS305-08