Turnstone TS 400A User manual

Page 1 of 4
TS400A Rev C
TS 400A Group Work Table R
©2001 Steelcase Inc.
Grand Rapids, MI 49501 U.S.A.
Printed in U.S.A.
1.  Attach legs to table top
Attach each leg to table top with ten
phillips head screws in the pre-
drilled holes as shown.
2.  Turn table over
Use two people to turn the table
over.
Please check all pieces before beginning project.
(this kit may contain extra screws for your
convenience.) If there are any problems or
discrepancies, call our customer service
departmentat 1-800-turnstone. TS40011 TS40012 TS40013

Page 2 of 4
TS400A Rev C
R
3. Aligning the template
STUD TEMPLATE
LATCH TEMPLATE
14" FROM CENTERLINE OF HOLES BEING USED
TO LEADING EDGE OF TABLE
AA
A A B
B
EDGE OF WORKSURFACE
FOLD DOWNWARD 90° ON THIS LINE
A=1/8" DIA. DRILL x 1/2" DEEP
B=13/16" DIA. DRILL x 1/4" DEEP
Fig. 1
CUT
CUT
CUT
a
STUD TEMPLATE
LATCH TEMPLATE
14" FROM CENTERLINE OF HOLES BEING USED
TO LEADING EDGE OF TABLE
AA
A
A
B
B
EDGE OF WORKSURFACE
STUD TEMPLATE
LATCH TEMPLATE
14" FROM CENTERLINE OF HOLES BEING USED
TO LEADING EDGE OF TABLE
AA
A
A
B
B
EDGE OF WORKSURFACE
FOLD DOWNWARD 90°ON THIS LINE
A=1/8" DIA. DRILL x 1/2" DEEP
B=13/16" DIA. DRILL x 1/4" DEEP
b

Page 3 of 4
TS400A Rev C
R
4. Aligning and attaching the latch and stud
a
SCREW
LATCH
WORKSURFACE
WORKSURFACE
b
c
d
SCREW

Page 4 of 4
TS400A Rev C
R
Latch Positions for Tops