Turnstone TS370-03 User manual

Page 1 of 2
TS3700345 Rev B
TS370-03/04/05
R
©2001 Steelcase Inc.
Grand Rapids, MI 49501 U.S.A.
Printed in U.S.A.
1. Attach control to seat
Turn the carton upside down and cover it
with one of the plastic bags. Place the seat
on it as shown. Finger tighten each of the
4 screws attaching the control (C) to the
seat as shown. Now tighten all 4 screws
firmly using a Phillips screwdriver.
3.Insert cylinder into base
With base resting on floor, insert
cylinder as shown.
2.Snap casters into base (if not already
assembled) Insert the shafts of the casters
into their corresponding sockets of the base.
Push in firmly. Stand the base upright.
ts370-03 ts370-04 ts370-05 C

Page 2 of 2
TS3700345 Rev B
fig. 1 fig. 2 fig. 3
A
BA
B
C
A
B
C
4. Assemble cylinder cover
Slide cylinder (A) up through cylinder (B) (see fig 1).
With cylinder (A) engaged with cylinder (B), slide
cylinder (C) down over cylinders (A and B) (see fig 2).
Refer to fig. 3 for completed assembly.
6. Attach the seat to the cylinder.
Insert the cylinder into the seat and
control plate assembly as shown. Sit
carefully down in seat to firmly position
assembly.
5. Place cover over the cylinder
A
B
C