Turnstone TS345B User manual

Page 1 of 2
TS345B Rev B
TS345B R
©2001 Steelcase Inc.
Grand Rapids, MI 49501 U.S.A.
Printed in U.S.A.
1. Finger tighten the 2 bolts with washers into the
crossrail between the side rails as shown.
(NOTE: There is a nail on each end of the
crossrail to stabilize the crossrail. Please
handle it with care.)
2.Place the seat between the side frames, over
the crossrail. Finger tighten the 2 bolts with
washers into the sides of the seat, as shown.
TS345-03
NOTE: Put the washers
on the bolts, before you
assemble the chair.
Backrest
Seat
CR

Page 2 of 2
TS345B Rev B
3.  Finger tighten the other 2 bolts
with washers into the sides of
the seat, as shown.
5.  Rotate backrest to upright
position, as shown. Finger
tighten the other two bolts
with washers into the sides
of the backrest, as shown.
Place the chair on a flat level
surface. Firmly tighten all bolts
with the supplied Allen Wrench.
4. Place backrest in a forward leaning position,
as shown. Finger tighten 2 bolts with washer
through the side frame into the backrest
as shown.