Tyger Armor TG-AM2T20208 User manual

TM
Customer Support 1-866-340-3038
1/3
TYGERARMOR
TM
PartsList
Driver Side Armor
Passenger Side Armor
x1
x1
8mm Lock Washers
x16
8-1.25mm x 30mm Hex Bolts
8mm x 24mm OD x 2mm Flat Washers
x16
x16
TG-AM2T20208
Passenger/Right Side Armor Illustrated
Front
Driver/left Side Armor Illustrated
Passenger/Right Side Armor Illustrated
Front
Driver/left Side Armor
BeforeInstallation
REMOVE CONTENTS FROM BOX. VERIFY ALL
PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY. ASSISTANCE IS HIGHLY RECOM-
MENDED.
Warning
To protect your investment, wax this product
after installing. Regular waxing is recom-
mended to add a protective layer over the
nish. Do not use any type of polish or wax
that may contain abrasives that could
damage the nish. Use mild soap to clean
the Side Armor assembly.
1-866-340-3038www.tygerauto.com[email protected]

2/3
Starting on the passenger side of the vehicle, locate and remove
the plastic plugs or hex bolts from the (4) factory mounting
location along the bottom of the body, (Figures 1 & 2). Brackets
must sit at against the oor panel, remove any excess sealant
as necessary.
STEP1
With assistance, line up the (4) mounting brackets on the Side
Armor with the factory holes in the body. Attach the Side Armor
to the factory locations with the included (8) 8mm Hex Bolts, (8)
8mm Lock Washers and (8) 8mm Flat Washers, (Figures 3 & 4).
Do not tighten hardware at this time.
STEP3
1-866-340-3038www.tygerauto.com[email protected]
Illustrated
Remove plastic
plugs (if equipped)
or hex bolts from
threaded holes
(Fig 1) Passenger/right Front Mounting Location
Front
Front
(Fig 2) Passenger/right Center (2nd) Location
Front
8mm x 30mm Hex Bolts
8mm Lock Washers
8mm Flat Washers
(Fig 3) Passenger/right front Bracket installed
Select the Passenger/right Side Armor assembly.
STEP2

Repeat Steps 1-4 for driver/left Side Armor installation.
STEP5
Do periodic inspections to the installation to make sure that all
hardware is secure and tight.
STEP6
Adjust the position as necessary and tighten all hardware.
STEP4
(Fig 4) Passenger/right Center Bracket installed
Front
8mm x 30mm Hex Bolts
8mm Lock Washers
8mm Flat Washers
Complete Installation
3/3
1-866-340-3038www.tygerauto.com[email protected]