U-Line H-3797 User manual

PAGE 1 OF 2 0313 IH-3797
πH-3797
6'STEEL ROLLING
SCAFFOLD
1-800-295-5510
uline.com
PARTS FOR BASE UNIT
ASSEMBLY INSTRUCTIONS FOR BASE UNIT
NOTE: Identify all components according to
chart above. If any components are missing or
damaged, contact Uline Customer Service.
1. Attach each side brace (C) to end frames (A) at the
desired platform height. Be sure the locking pins on
each side brace are fully locked in the end frame at
all 4 locations. (See Figure 1)
2. Install platform (B) so that it is fully seated and level
in both side braces (C) Be sure the deck pins are in
the engaged position. (See Figure 2)
3. Install 4 casters (E) into both end frames (A) and
secure with snap pins (D). (See Figure 3)
WARNING! Side braces must be level and
locked before using. All 4 casters must be
locked before use. Follow all applicable ANSI
and OSHA guidelines along with state and
local codes for use of the product.
A
C
E
B
D
#DESCRIPTION QTY.
AEnd Frame 2
BPlatform 1
CSide Brace 2
D Snap Pin 4
E5" Caster 4
Locked
Unlocked
Engaged
Disengaged
Locked
Unlocked
Figure 1
Figure 2 Figure 3

PAGE 2 OF 2 0313 IH-3797
NOTE: If the desired platform height is between
6' and 11' 6" additional unit is required.
WARNING! When stacking second unit,
outriggers and guardrails are required. Do not
stack more than 2 units high. All scaffolds must
be restrained from tipping.
1. Install caster (E) into outrigger (C) and secure with
snap pin (D). Repeat for remaining 3 outriggers.
(See Figure 4)
2. Install outriggers (C) by clamping to end frames
perpendicular to the side braces. Clamps must be
tight and casters must make contact with the floor.
Set caster brakes. (See Figure 5)
3. Install end frames of upper unit onto end frames
of the base unit. (See Figure 6) Insert 4 snap pins
to secure scaffold units. Attach 2 side braces
to upper end frames at desired platform height.
Place platform so that it is fully seated and level in
both side braces. Be sure the deck pins are in the
engaged position.
4. Install guard rail panel into side brace sockets and
secure with lock pin. (See Figure 7) Guard rail gate
must swing inward above platform. Repeat for other
side.
WARNING! Guard rail gate must swing inward
above platform. Make sure each scaffold
level has both side braces installed. Follow all
applicable ANSI and OSHA guidelines along
with local codes for the use of this product.
Outrigger
End
Frame
Tighten
Side
Brace
Socket
Snap
Pin
PARTS FOR STACKING ADDITIONAL UNIT
ASSEMBLY INSTRUCTIONS FOR STACKING ADDITIONAL UNIT
#DESCRIPTION QTY.
AGuard Rail Panel/Gate 2
BLock Pin 4
C18" Outrigger 4
D Snap Pin 4*
E5" Caster 4*
*From additional unit.
A
C
B
E
D
Figure 4
Figure 6
Figure 5
Figure 7
π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com