Uplift Desk UDA116-SML User manual

Step 3
Unlatch the latches under your worksurface, and slide the
Keyboard tray into the slots underneath the Main unit’s
worksurface. Once inside, ip the latches back up to secure
the Keyboard tray.
Step 2
Raise the Main unit to a higher position so that you can easily
access the space underneath. Grip the handle on the right
side, squeeze, and lift.
It is advised you hold onto it with two hands as you raise and
lower the worksurface.
Main unit Keyboard tray Cable mounts
(qty 4)
Velcro sheath
(qty 1)
UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com
®
Step 1
Unpack the box and verify the contents against the parts
above. Clear off the surface you intend to use the unit on,
and ensure there is at least 29’’w by 26’’d space for it.
Two people should lift the Main unit and place it on the
intended surface.
Package contents
UDA116-SML/R01
Step 4
You can now add your devices and work items to the unit.
Keep them centered and away from the edge of the main
worksurface, to prevent them from falling.
Do not place your monitors on the edge of the unit.
XF Standing Desk Converter, Small, Instructions
UDA116-SML

UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com
Step 5
Be mindful of any wires hanging from your worksurface. Keep
them clear of the cross joints and tracks of the Main unit.
To gather several cables together, use the Velcro sheath.
Open it and run your cables through it, then close. This will
keep all cables together.
The Cable mounts can be placed on the back or under your
table to further secure your cables and keep them from mov-
ing too much. Just make sure that there is enough slack in
the wires to allow the unit to raise and lower without pulling
your devices off the work surface.
Copyright Notice: These instructions are a component of the UPLIFT Desk XF Standing Converter, small. These instructions are part of the scope of delivery, even if the item is resold. These instructions are
also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk.
These instructions are subject to United States copyright law.
©
!
!
!
!
!
!
!
CAUTION: Keep hands clear during operation! Do not reach into the mechanism near the
gas spring.
CAUTION: Read all instructions before assembly. Failure to assemble properly may result
in damage or personal injury.
CAUTION: The maximum load capacity of the unit is 33 lbs for the upper worksurface
and 4 lbs for the keyboard tray. Do not overload.
CAUTION: Keep devices centered and away from the edge of the main worksurface, to
prevent them from falling.
CAUTION: Make sure that the wires for your devices have enough slack. This will prevent
your devices from being pulled off the unit workstation when raising the unit.
CAUTION: When moving the unit, remove all devices to avoid harm or damage, and ad-
just the unit to its lowest position.
CAUTION: When moving the unit, move it carefully with two people, to avoid injury and
damage to the product and surroundings.
CAUTIONS & WARNINGS
!