Uplift Desk UPL127 User manual

Adhesive pads
(optional. qty 4)
5/8’’
Wood screws
(qty 8)
Track
Front bumper
Back bumper
Machine screws
(qty 4)
Acorn nuts
(qty 4)
Cord catcher
Mousepad
Keyboard tray
Palm support
Mechanism
© UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com
Package contents
®
Large Keyboard Tray
UPL127
Step 1
Take the Track and place underneath your desktop, in order to gure out
where to place it. If there are pre-drilled holes in your desktop, line the
track up with the holes, or you can pre-drill your own 1/8” pilot holes. Be
sure to leave about 1/2” from the front edge of the desk.
Use eight (8) Wood screws to attach the track to the desktop, and one more
screw to attach the rear bumper as shown.
Step 2
With the desk right side up, line up the mechanism with the grooves on the
track and slide it in.
Please note: the mechanism will not adjust up or down until the tray has
been attached and the shipping pin is removed (see steps 3 and 4).
Step 3
Attach the tray to the mechanism by lining up the holes in the tray with
the holes on the mechanism, and secure by inserting the four (4) Machine
screws through the holes, and screwing the four (4) Acorn nuts onto them
from below.
Step 4
Lift up on the front of the tray and lower the back to relieve pressure on
the shipping pin and remove it.
UPL127/R02

© UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com
Copyright Notice: These instructions are a component of the UPLIFT Large Keyboard Tray. These instructions are part of the scope of delivery, even if the item is resold.
These instructions are also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or copies may not be forwarded to third parties or used in any other published
form without the prior written consent of UPLIFT Desk.
These instructions are subject to United States copyright law.
©
Step 5
Finally, lower the tray, slide it back on the track and install the front
bumper.
Step 6
Attach the foam palm support onto the front of the tray. Place the mouse-
pad and cord catcher to the desired side.
The non-slip Adhesive pads can be placed over the heads of the machine
screws, or in any other position on the board.
Tilt
To adjust the tilt of the tray, turn the knob at the center of the tray.
Height
To adjust the height of the tray up and down, push down on the back of the
tray while lifting the front.
Rotate
The Keyboard Tray rotates at the point where the mechanism attaches to the
Track. It can rotate 360 degrees.
Adjustment Guide
360°