V-TAC VT-08 User manual

INSTALLATION INSTRUCTION
WEEE Number: 80133970
LED BULKHEAD
INTRODUCTION & WARRANTY
TECHNICAL DATA
Thank you for selecting and buying V-TAC Product. V-TAC will serve you the best. Please read
these instructions carefully before starting the installing and keep this manual handy for future
reference. If you have any another query, please contact our dealer or local vendor from whom
you have purchased the product. They are trained and ready to serve you at the best. The
warranty is valid for 5 years from the date of purchase. The warranty does not apply to damage
caused by incorrect installation or abnormal wear and tear. The company gives no warranty
against damage to any surface due to incorrect removal and installation of the product. The
products are suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a day would
void the warranty. This product is warranted for manufacturing defects only.
5
YEAR
WARRANTY
*
Model Was Lumens Input Power IP Rang Microwave Sensor
Emergency Baery
Backup
VT-08 8w 720 NO NO
VT-09 8w 720 YES NO
VT-11 10w 720 NO YES
VT-12 10w 720 YES YES
VT-15 15w 1400 NO NO
VT-16 15w 1400 YES NO
VT-17 17w 1400 NO YES
VT-19 17w 1400 YES YES
AC200-240V
50/60 Hz IP65

INSTALLATION INSTRUCITONS
STEP 1
Remove the cover by twisng the diuser an-clockwise and set aside. Carefully remove the LED tray and unplug it
from the LED driver, and set aside
STEP 2 STEP 3
Hold the product in place, mark & drill the holes Make the AC Power conneon through the
into the wall and nail the alligator into the hole. waterproof rubber cap.
STEP 4
Install the LED tray and diuser back and switch on.
SENSOR WIRING DIAGRAM

In case of any query/issue with the product please reach out to us at [email protected]
V-TAC EUROPE LTD, Bulgaria, Plovdiv 4000, bul.L.Karavelow 9B
SENSOR SETTINGS
Detec Hold Daylight Stand-by Stand-by
Area Time Threshold Period dimming level
It can be The me period Daylight sensor The is the me period the is the dimming
adjusted by the light will priors moon the light keeps dimming level, the light keeps
combining be ON aer the sensor. Set down aer the last during the stand-by
DIP switches for last detecon. Threshold for detecon. Period.
speciapplicaon. Specineeds.
If disabled, only
moon sensor
will work
APPLICATION (Funcn Demo – Dimmable Control/Corridor funcn)
When mo is detected, when mon is detected, Aast den, the A stand-by period,
but the daylight is suient, and the daylight is light will be dimmed down the light will be OFF.
enough, the light will insucient, the light to stand-by dimming level
remain OFF. will be ON. (10%, 30%).
Pre-Install Emergency funcon test.
-Connect the AC cable according to the below diagram
-Press the test buon on the driver. The emergency funon will be acvated, and the charging indon will be o.
-Disconnect the bay pack, the charging indicated LED o.
NOTE: Ar installn, allow 36 hours to ensure full baery charge and then interrupt the supply.