• Please make sure to turn o the power before starting the installation.
• Installation must be performed by a qualified electrician.
• The light source of this luminaire is not replaceable, when the light source reaches its end of life the whole luminaire
should be replaced.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer
or his service agent or a similar qualified person in order to avoid a hazard.
• Proper grounding should be ensured throughout the installation.
• Terminal block not included.
• To be connected with waterproof cable hose.
• Replace any cracked protective shield.
Replaceable (LED only)
light source by a professional
LED LINEAR HIGHBAY
INSTRUCTION MANUAL
TECHNICAL DATA
VT-91100 8700LM7892,7893 115° 510x97x53.2mm 0.59 <5M
-20° to +45°C>0.9 25,000
Hours
>70100 W AC:220-240V
50/60Hz
MODEL SKU WATTS LUMENS
@WIDE CONE CRI DF OPERATION
TEMPERATURE DIMENSION INPUT POWER N.W
(KGS)
MAX
MOUNTING
HEIGHT
BEAM
ANGLE
LIFE
SPAN
INTRODUCTION AND WARRANTY
INSTALLATION DIAGRAM
INSTALLATION INSTRUCTION
DISASSEMBLY DIAGRAM
WARNING
'This product contains a light source of energy eciency class <F>', where <F> shall be replaced by the
energy eciency class of the contained light source.
Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instructions carefully
before starting the installation and keep this manual handy for future reference. If you have any another query, please
contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you
at the best. The warranty is valid for 2 years from the date of purchase. The warranty does not apply to damage caused
by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due
to incorrect removal and installation of the product. The products are suitable for 10-12 Hours Daily operation. Usage of
product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only.
This marking indicates that this
product should not be disposed
of with other household wastes.
Caution, risk of electric shock.
Step 1: Switch OFF the power
Step 2: Install the expansion hook onto the wall
Step 3: Hang the installed Highbay into the top hook through a steel wire rope (as shown in the figure3)
Step 4: The input line is connected to the "L" live wire in brown, the "N" zero wire in blue, and the yellow green wire
is connected to the ground wire. Aer connecting the wires, it is necessary to use insulation tape and waterproof
tape for insulation and waterproofing treatment. It is recommended to use a professional waterproof junction box.
Step 5: Swith ON the power and test
