V-TAC VT-8006 User manual

INSTALLATION INSTRUCTION
WEEE Number: 80133970
INTRODUCTION
Thank you for selecng and buying V-TAC LED product. V-TAC will serve you the
best. Please read these instrucons carefully before starng the installing and keep
this manual handy for future reference. If you have any other query, please contact
our dealer or local vendor from whom you have purchased the product. They are
trained and ready to serve you at the best.
LED DOME LIGHT

INSTALLATION INSTRUCTIONS
• Switch off the power.
• Remove the cover and the diffuser of the dome light.
• Connect the power wire and ghten the plasc cable glands.
• Fix the light on the installaon surface.
• Install the diffuser and the cover back to the dome light.
• Switch on the power if the instrucons above are done properly with
no mistakes.

In case of any query /issue with the product please reach out to us at [email protected]
WARRANTY
WARNING
NOTICE
• Read thoroughly before installing- the luminaire shall be installedby a qualified
electrician.
• Strictly follow these instrucons for installing, avoid the intensity of power cable
during installing.
• Suitable for a Maximum use of 10-12 Hours Daily. Usage of product for 24Hours
a day would void the warranty.
• Once the sensor is installed to the luminarie, there will be a delay before the
lamps will light due to theso-start circuitry of the driver.
• This is a high-powered LED. As with any light source, direct viewing should
be avoided.
• Note: Although easy to fit, this lamp requires wiring to the main and safety
should only be fied by a qualified electrician.
• Having issued this warning, the company accepts no responsibility for issues
arising for any failures to comply with these clear instrucons.
• The company will not accept any responsibility for any other issues from
improper use of fing of this product as these maers are beyond our control.
• This product is warranty from manufacturing defect only.
• The warranty is valid for 2 years from the date of purchase.
• The warranty does not apply to damage caused by installaon or abnormal
wear and tear.
• The company gives no warranty against damage to any surface due to incorrect
removal and installaon of the product.