Vidyo VidyoRoom HD2 User manual

Part Number: DEV-ACC-DOC-GSG2A-A
© 2019 Vidyo, Inc. all rights reserved. Vidyo’s technology is covered by one or more issued or pending United States patents, as more fully detailed on the Patent Notice page of Vidyo's website
http://www.vidyo.com/about/patent-notices/, as well as issued and pending international patents. The VIDYO logotype is a registered trademark of Vidyo, Inc. in the United States and certain other countries, and is a
trademark of Vidyo, Inc. throughout the world. VIDYO and the Vidyo family of marks are trademarks of Vidyo, Inc. in the United States and throughout the world.
VidyoRoom™ HD2
Getting Started Guide
What’s Included
Your HD2 codec is shipped with the following items:
VidyoRoom HD2
Power cables for the United States, Europe, and Ireland/United
Kingdom –total length 6 ft (1.828 m)
HDMI to HDMI Cable –6 ft (1.828 m)
Mini DisplayPort to HDMI adapter.
Ethernet cable, Cat5E –7 ft (2.13 m)
Serial to USB adapter –1 ft (.30 m)
Infrared remote control with 2 AAA batteries
External infrared receiver with USB cable –6 ft (1.828 m)
Please refer to the diagram on the next page to better understand how to connect peripherals to the VidyoRoom HD2.
To view a list of peripherals compatible with VidyoRoom, go to http://www.vidyo.com/support/peripherals.
Please refer to the VidyoRoom Administrator Guide to complete the setup of your VidyoRoom HD2.

Installing Your HD2 –Diagram
VidyoRoom HD2 (Front)
- HDMI to USB3
- VGA to USB
- DVI to USB3
Note: Only connect one Inogeni device to
front USB ports.
VidyoRoom HD2 (Back)
Share Device Solutions
USB camera
Display 1
Display 2
Mini DisplayPort to
HDMI Adapter
VISCA to
Serial Cable
USB cable
IMPORTANT!
Note: When available, set to #7 and use the VISCA
cable to allow VidyoRoom controls to move your
camera. Make sure it is connected to the bottom
USB port.
Serial to
USB
Adapter
USB Audio Device
Control Solutions
Radiofrequency Transceiver
DEV-ACC-RM-RF-REMOTE
(for use when RF remote is purchased)
Infrared Receiver
(for use with IR remote)
USB cable

Configuring Supported Television Picture Settings
If the edges of the VidyoRoom UI are cut off, like in the screenshot below, please see the table at the bottom of this page to reconfigure the alignment.
The following table describes how to configure supported television picture settings in order to properly align the user interface.
LG
Samsung
Sharp
Sony
Vizio
1. Press Menu on your TV
remote.
2. Select Picture > Picture
Options.
3. Select Just Scan.
1. Press P. Size on your TV
remote.
2. Select Screen Fit.
1. Press Menu on your TV
remote.
2. Select Picture > Advanced
Settings.
3. Turn Overscan Off.
1. Press Wide on your TV
remote.
2. Select Wide Mode > Full.
1. Press Display on your TV
remote.
2. Select Normal.
For more information, refer to the documentation provided with your television.