Vision Fitness X6600HRT/DA User manual

Guide
Assembly
X6600HRT/DA
DUAL-ACTION ELLIPTICAL TRAINER

To avoid possible damage to this Elliptical Trainer, please follow these assembly steps in the correct order. Before proceeding
though, find your new Elliptical Trainer’s serial number located below the power switch, and enter here:
Refer to this number when calling for service, and also enter this serial number on your Warranty Card and in your own records.
Be sure to read your Owner’s Guide before using your new Elliptical Trainer.
If any parts, hardware or tools are missing, please call 1.800.335.4348, Extension 12
NOTE: It is recommended that you apply grease to the threads of each bolt as you assemble your Elliptical Trainer, to prevent
loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt.
dual-action elliptical trainer
1
STEP
2
STEP
3
STEP
4
STEP
5
STEP
X6600HRT/DA

5MM Allen Wrench
Screwdriver
6MM L-Shaped Wrench
TOOLS & PARTS INCLUDED
PARTS BOX
Heart Rate Chest Strap, Qty: 1
Power Supply, Qty: 1
Arm Bracket Covers, Qty: 2
Logo Endcaps, Qty: 2
Stabilizers, Qty: 2
Stabilizer Covers, Qty: 2
Water Bottle and Holder, Qty: 1
Console Mast Cover Plate, Qty: 1
Assembly Guide
Owner’s Guide
Warranty Card
Parts Bags
Tools

BLUE BAG
ORANGE BAG PINK BAG
HARDWARE INCLUDED
M8 x 75MM Bolt
Quantity: 2
M4 x 12MM Screw
Quantity: 4
M3 x 10MM Screw
Quantity: 1
M4 x 12MM Screw
Quantity: 4
M8 Arc Washer
Quantity: 4
M8 x 12MM Bolt
Quantity: 2
M20 Spring Washer
Quantity: 2
M30 Washer
Quantity: 2
M30 Teflon Washer
Quantity: 2

5
1
STEP
2
STEP
1
STEP
• Install the left and right
stabilizers with the four arc-shaped
washers (M8) and four bolts (M8 x
20), using the Blue 5MM Allen wrench.
• Cover both stabilizers with the
included rubber boots.
ORANGE BAG
2
STEP
• Slide the console mast cover onto
the console mast.
• Unfold the console cable and
attach it to the string located inside the
console mast. Guide the wire up
through the mast while simultaneously
sliding the console mast onto the
frame bracket.
• Attach the console mast cover to the
frame using four screws (M4 x 12).
• Bolt the mast to the frame with the
two bolts (M8 x 75), using the
5MM Blue-handled Allen wrench. Make
sure these are tight!
• Attach the console mast cover plate
with the V-head screw (M3 x 10).
BLUE BAG