VISIONARY DESIGNS MOD-9002 User manual

© 2020
Order #XXXXX
Locked layer contains
placeholder marks.
Completed Assembly
Steps:
1) Attach base plate to bottom of post, using bolt.
2) Slide assembled header frame, over connector, on top of post.
3) Attach graphic to clamps. See A10 Clamp detail.
Bolt
Base
Plate
Z-Plate
Graphic
Post
Header
Frame
Connector
Header Frame Assembly
1) Attach frame pieces together, as shown,
with graphic infill between.
2) Attach vertical to bottom of assembled frame.
12.52” extrusion
12.52” extrusion
15” extrusion
10” extrusion
15” extrusion
G
r
a
p
hi
c Infil
l
Header frame stays assembled, when packing.
Slide header frame, over
connector, on top of Z-plate.
Connector
Z-Plate
Header Frame
A10 Clamp
Tighten knob to secure
graphic into clamps.
Keep connectors, clamps, and Z-plate attached to post,
when packing.
MOD-9002 Hand Sanitizer Stand with Graphic
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS

© 2020
Order #XXXXX
DO NOT USE POWER TOOLS
DO NOT USE SCREWS
THAT ARE STRIPPED
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all set screws
and locks during disassembly.
Hex Tool - Essential for Assembly
General Information