VISIONARY DESIGNS LTK-1016 Manual

© 2018
Order #XXXXX
Top View
Cabinet Base Assembly
Door
Completed Assembly
Front View Back View
1 2 3
8
9
Counter Top
Counter Top
1
Wing Nut
Shelf Support
Shelf Support
Shelf Support
Shelf Support
Wing Nut
Bolt
Cabinet Top
Cabinet Top
Bolt
Bolt
Shelf
7 6 5
48
Item
1
2
3
4
5
6
7
8
8
9
Qty.
1
1
1
1
1
1
1
1
1
1
Description
42” 90° LT-Connector
19” LT-Panel w/ Door
42” 90° LT-Connector
19” LT-Panel
42” 90° LT-Connector
19” LT-Panel
42” 90° LT-Connector
19” LT-Panel
37.25” Vertrical Extrusion
Flange Plate
1
2
3
7
6
5
4
8
*
2
345
Counter Top
Attachment
Insert fixed screws, located
on underside of counter top,
into holes on flange plate
then secure with wing nuts. Wing Nut
*
Steps:
1) Connect panels and connectors [1-8] together in numerical order.
2) Connect [9] to the top of verical [8], using bolt.
3) Attach counter top to flange plate [9]. See Counter Top Attachment detail.
4) Attach shelf supports to Velcro on interior of cabinet base, then place
shelf on top of supports.
5) Place cabinet top on top of assembled cabinet base.
6) Attach counter top to cabinet base, using bolts and wing nuts.
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
LTK-1016 Counter

© 2018
Order #XXXXX
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all setscrews
and locks during disassembly
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED
General Information