VISIONARY DESIGNS MOD-1128 Manual

© 2016
www.classicexhibits.com
Order #XXXXX -
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
MOD-1128 - Assembly
1
2
3
4
58
6
7
8A
7A 6
5
Counter
When Assembled
Internal Shelf
Item
1
2
3
4
5
6
7/7A
8/8A
9
Qty
1
1
1
1
2
2
2
2
1
Steps
1)
Connect lower horizontal extrusions [5, 6, 7, and 8] between
vertical extrusions [1, 2, 3, and 4].
2) Connect extrusion [9] next to vertical extrusion [3] and atop
of horizontal extrusion [6] as shown.
3) Place inserts and door as shown.
4) Connect upper horizontal extrusions [5, 6, 7A, and 8A] between
vertical extrusions [1, 2, 3, and 4] and
atop inserts, door, and extrusion [9].
5) Attach light reflector as shown.
6) Place internal shelf and Counter atop assembled base and lock in place.
Description
41.5”h 90° Vertical extrusion
41.5”h 90° Vertical extrusion w/ Door Stop
41.5”h 90° Vertical extrusion
41.5”h 90° Vertical extrusion
30.1256” Curved Horizontal extrusion
25” Horizontal extrusion
18.371” Horizontal extrusion mitered both ends
18.371” Horizontal extrusion mitered both ends
37.918”h Vertical extrusion w/ Door Hinge
9
9
Insert
Insert
Door
Align hole with pin Rotate pin. Spring
will push pin into hole.
Counter Top Attachment
12
*
*
*
Insert

© 2016
www.classicexhibits.com
Order #XXXXX -
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all setscrews
and locks during disassembly
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED
General Information

© 2016
www.classicexhibits.com
Order #XXXXX -
Case 1 of 1
Case Packing - 1 of 1
Top View of Each Level
Level 1 Level 2 Level 3 Level 4 Level 5
Shelf Supports
5 5
6 6
9
7
1
7A
2
8
4
8A
3
Shelf
Counter Top
Level 5
Assembled
Pedestal
Door
Pedestal Side
Assembly
Pedestal Side
Assembly