2
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual and do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly, or
inappropriate use.
WARNING!
ELECTRICAL SAFETY INSTRUCTIONS
THIS PRODUCT IS POWERED BY ELECTRICITY. IN ORDER TO AVOID BURNS, FIRE AND ELECTRIC
SHOCK, PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY.
• DO NOT CLEAN PRODUCT WHILE POWER IS CONNECTED.
• DO NOT DISASSEMBLE OR REPLACE COMPONENTS WHILE POWER IS CONNECTED.
• NEVER OPERATE THE SYSTEM WITH A DAMAGED CORD OR PLUG. PLEASE CONTACT YOUR
SELLER TO REPLACE DAMAGED PARTS.
• NEVER OPERATE SYSTEM IN DAMP ENVIRONMENTS OR IF ANY ELECTRICAL COMPONENTS HAVE
MADE CONTACT WITH LIQUIDS.
• ALTERATIONS OF THE GIVEN POWER UNIT ARE NOT ALLOWED.
• OUTDOOR USE IS PROHIBITED.
OPERATING INSTRUCTIONS: When the system is powered on, you will hear a beep and the existing desktop
height will be displayed on the control panel.
Upward and Downward Movement
Press and hold the up or down arrow until the desk reaches the desired height.
Memory Mode
To store a certain height in the controller’s memory, first press “M”. The letter “S-” will be displayed. Now
press “1”, “2” or “3” to store the current height in memory. Each number can store a dierent height. Once in
memory, you can recall any of the three height settings by pressing the corresponding button.
Timed Reminder Mode
To set the timer, press “A”. The display will flash “00” representing 0 minutes, and the screen will begin
flashing aer 2 seconds. Now press the up or down arrows to adjust the time (default setting is 45 minutes).
Wait 5 seconds, and the set time will be saved and the countdown will begin. When the timer has reached
the set time, the controller will beep for 10 seconds, reminding the user to adjust the working position. If
no action is taken, the controller will beep again aer 5 minutes. The timer will automatically turn o if no
action is taken aer the second reminder. To deactivate the timer, press and hold “A” for 3 seconds, and the
display will show “OFF”.
Reset Mode
While the unit is powered on, press the down arrow until the desk moves to the fully lowered position.
Restart the system by unplugging for at least 5 seconds and plug back in, then hold the down arrow until
RST is displayed. Continue holding the down arrow and the desk will move to the lowest position, then raise
slightly and stop to complete the reset process.
Anti-Collision Sensitivity Adjustment
Press and hold the up and down arrows together for 5 seconds to switch to the anti-collision sensitivity
adjustment. Sensitivity is set to A-3 (high) by default. Use the up and down arrows to scroll through A-0 (o),
A-1 (low), A-2 (medium) and A-3 (high). Wait 5 seconds, and the setting will be saved. With anti-collision on,
the desk will stop and reverse slightly to avoid damage.
OPERATING CONTROL PANEL
