Weber Pellet Pro Stacker Ring User manual

Pellet Pro® Stacker Ring for Weber
WSM Grill Instruction Manual

Items Included:
WSM Spacer Ring
Pellet Pro® Pellet Hopper
Attachment Brackets
Fastenings
Pellet Hopper Support Leg
Extra Long RTD Probe
(4) Strips of Heat Resistant Aluminum Tape
Tools Required:
Phillips Screwdriver
7/16” Wrench
10mm Wrench
1. Attach the brackets to the outside of the ring with a Phillips
screwdriver and a 7/16” wrench.
 Be sure that the side of the bracket at about 120° is bolted to
the ring, with the square side outward.
2. Once brackets are place, flip the stacker ring so that the opening
is closer to the bottom of the ring and slide the Pellet Pro® Pellet
Hopper through the opening from the outside.
2
Larger
Smaller

3. Then, use a 10mm wrench to attach the stacker ring brackets to
the Pellet Pro® Pellet Hopper with the 10mm bolts.
4. Use two pieces of tape in order to separate the backing of the heat
resistant aluminum tape strips. Then take the strips of aluminum
tape and cover the gap between the spacer ring and hopper arm.
5. With the Pellet Pro® on its side, attach the leg by sliding the clips
on the bottom of the hopper and tighten down the thumb screws.
3

6. Connect the RTD wire ends.
7. Place the spacer ring on the bottom portion of the WSM smoker
and on top of that, the top portion of the WSM smoker.
 Install the metal RDT grommet into the existing hole as
shown. You will need to remove the bolt prior to installing
the grommet.
You are now ready to fire up your WSM Weber
with our Pellet Pro® Pellet Hopper!
4