WYLER Clinotronic S User manual

Clinotronic S
Quick Reference
Release 4.0
Technical changes reserved 1 947-QR-0006-E
WYLER AG
Im Hölderli 13 Tel. [phone] Outside Switzerland:
8405 Winterthur Email: [email protected]m contact our representatives
Switzerland Website: www.wylerag.com
Thank you for choosing WYLER!
Read this quick reference before start working with the Clinotronic S.
Please observe the safety instructions.
Brand and Type Art. 015-S-XG45 without inserts
Brand Clinotronic S, Types Art. 015-S-HG45 with 2 magnets each side
Art. 015-S-PG45 with 2 threats M3 each side
Art. 015-S-UG45 with 2 magnets and 2 threats M3 each side
Warning! The following sign is used in this Quick Reference:
This is intended to indicate special dangers
Safety instructions
- The Clinotronic S complies with the applicable directives and standards, see:
- This Quick Reference - The nameplate on the back of the device
-The manual with the CE Declaration of Conformity Clinotronic S at www.wylerag.com
WAR
Intended Use
-The Clinotronic S is designed exclusively for measuring inclination angles.
-Attention! There is no other use!
Not intended use
- The device does not serve as a support in vices! The precise housing can deform.
- Do not immerse underwater! Since the device may suffer a short circuit inside.
- Do not use as a hammer! The damaged measuring surfaces are then no more precise.
- Do not throw the device! The housing can cause serious injury.
WARNING
- Do not use this device near sources of strong electromagnetic energy Radiation (e.g.,
unshielded radio frequency source) because they can interfere with operation.
- Only the original WYLER AKKUS may be used.
- The batteries may only be charged with the included chargers.
- The batteries may only be charged supervised. Do not leave the batteries lying around
- The batteries must not be charged at temperatures below 0 ° C
- The batteries must not be discharged at temperatures below -20 ° C.
- Close the battery cap on the device carefully, but not by
force! For the tightness of the closure, an O-ring is mounted.
- Observe the current regulations of the airlines regarding the
Transports of lithium-ion batteries in hand luggage and in checked baggage!
- Do not immerse the device in water! Underwater, the built-in short-
circuit securing your effect!
Technical data, Mass, Weight, Protection, Operation, Storage
Measuring Range:
45°
Dimension L x H x D:
100 x 75 x 30 mm
Weight:
400 g
Protection:
IP64
Weight Scope of delivery:
850 g
Storage:
-20° bis +60° C
Operation temperature:
0° bis 40 °
Decommissioning, disposal
- When decommissioning the Clinotronic S, follow the local regulations for Disposal
of electronic waste.
- The batteries must be removed from the device and both parts separately
from the be supplied for proper disposal.
Optional scope of delivery (accessories see www.wylerag.com)
1- Case for storage, transport and shipping for repair
2- Clinotronic S (standard) 3- Li-Ion Battery (standard)
4- Battery Charger 5- USB cable
6- wylerTRIGGER 7- wylerCONNECT MINI, Bluetooth
- Quick reference (Manual see: www.wylerag.com)
WARNING
Warning

Clinotronic S
Quick Reference
Release 4.0
Technical changes reserved 2 947-QR-0006-E
Control elements
1
2
6 3
4 7
5
1 Screen
2-5 Membrane keyboard
6 Akku cover
7 USB-Connection
8 wylerTRIGGER
Charging of Clinotronic S
Overview Screen, Keyboard
1 Screen
2 Serial number; 2a IR-number +red blin
3 Display of angle (depending on the selected unit)
4 Radio activated,
5 Charging indicator
6 Type of measurement: ABS=Absolute; REL=Relativ Zero
7 Local gravity is set.
8 Calibration performed with Clinomaster
9 Optical display of the entire measurement range
10 Optical display of the angle range close to zero
11 Gradient triangle and plus / minus signs
according to inclination
-------------------------------------------------------------------------
12 Units 15 Arrow downwards Short cut "Relative Zero"
13 On/Off Menu: Arrow Pfeil upwards 16 Cancel Menu: Cursor left
14 Menu Menu: Enter, Submenu: Cursor to the right
Power on: Press the button (13) the screen will start immediately.
Switch off: Press the button (13) until the message appears: Power off
Menu: Press the button (14) to get Menu "Settings"
Menupoints:
- Device
- Unit
- Measurement
- Device Information
- Use the up arrow and down arrow to move the cursor up and down.
- Use to select the desired menu item in the menu
- Use the "Back" button to return to a menu level or to return to the measuring mode.
Reversal Measurement (elimination of zero drift)
Enter with the Menu "Measurement". Choose with "Absolute Zero"
After that:
The menu guides you live through the reversal measurement.
For more information, read the manual at www.wylerag.com
Connect the Clinotronic S with the power supply using the cable
Plug the charger into a power outlet (100-240V)
Important: Press to start charging the device.
It does not start charging automatically!
It is not possible to measure in charging mode!