VER. 003_20.05.2011
FUNCTIONING, MOUNTING
APPLICATION
Bypressingthebutton, thetransmittersendsasignalwith868,32 MHzfrequencywhichcontrolsEXTAFREEreceivers.Device pro-
gramming procedure (adding a transmitter to a receiver’s memory) is described in particular EXTA FREE manual instructions.
The device range (up to 250 m depending on a receiver) can be increased by means of a retransmitter or few RTN-01 retransmitters.
The device can be mounted in any place by means of double-sided adhesive tape or wall plugs 5 x (3 x 30) mm.
Mounting by means of wall plugs:
1. Remove push-buttons - to do it press a push-button
on one side, and on the other side put a screwdriver
into a slot and lift it up.
2.Findaplaceonthewalltomountthetransmitter,
make two holes corresponding mounting holes
from the transmitter’s base.
3. Set wall plugs in the holes.
4.Fix the base by tightening the screws into wall
plugs.
5. Place the push-buttons back.
BATTERY CHANGE
Battery discharge status is signalled by several
LED red diode ashes during transmission time.
1.Removepush-buttons(Fig.1).
2. By means of a screwdriver lever up the printed-
circuitboardreleasingthebottomlatch(Fig.2)and
remove it from the base.
3.Removethebatteryfromthelatch.(Fig.3)
4. Mount a new battery. Watch battery polarisation
marked on the latch. Wrong battery mounting
may cause device damage.
5. Put the removed printed-circuit board back in
the base.
6. Place the push-buttons back.
CAUTION: While changing the battery, it is suggested to press any of the buttons for about 5 seconds before putting it into
a latch. Next press transmission button several times to check its operation. If the transmitter does not work properly repeat
the battery change procedure.
УстройствафирмыZAMEL
имеющиетакойзнак,
могутработать
другсдругом.
COOPERATION AND OPERATING RANGE
Symbol ROP-01 ROP-02 ROB-01 SRP-02 SRP-03 RWG-01 RWL-01 ROM-01 ROM-10 RDP-01 RTN-01
RNK-02 180 m 200 m 200 m 200 m 200 m 250 m 180 m 250 m 250 m 180 m 250 m
RNK-04 180 m 200 m 200 m 200 m 200 m 250 m 180 m 250 m 250 m 180 m 250 m
CAUTION: The given range concerns open area - an ideal condition without any natural or articial obstacles. If there are some obstacles between a transmitter and a receiver,
it is advisable to decrease the range according to:
wood and plaster: from 5 to 20 %, bricks: from 10 to 40 %, reinforced concrete: from 40 to 80 %, metal: from 90 to 100% , glass: from 10 to 20 %, Over- and underground
medium and high electrical power lines, radio and television transmitters, GSM transmitters set close to a device system have also a negative inuence on the range.
КнопочныйрадиопередатчикRNK-04,
управляющийработойдистанционного
выключателяосвещенияRWL-01(вкл/
выкл),встраиваемогорадиодиммера
RDP-01(вкл/выклилиосветление/
затемнение)иливстраиваемым
контроллеромрольставнейSRP-02
(поднимание/опусканиерольставней).
рис.1
рис.2 рис.3
WARRANTY CARD
There is 24 months guarantee on the product
1. ZAMEL provides a two-year warranty for its products.
2. The ZAMEL warranty does not cover: a) mechanical defects resulting from transport, loading / unloading or other circumstances
b) defects resulting from incorrect installation or operation of ZAMEL products; c) defects resulting from any changes made by CUS-
TOMERS or third parties, to products sold or equipment necessary for the correct operation of products sold; d) defects resulting
from force majeure or other aleatory events for which ZAMEL is not liable; e) power supply (batteries) to be equipped with a device
in the moment of sale (if they appear);
3. All complaints in relation to the warranty must be provided by the CUSTOMER in writing to the retailer after discovering a defect.;
4. ZAMEL will review complaints in accordance with existing regulations.;
5. The way a complaint is settled, e.g. replacement of the product, repair or refund, is left to the discretion of ZAMEL.
6. Guarantee does not exclude, does not limit, nor does it suspend the rights of the PURCHASER resulting from the discrepancy
between the goods and the contract.
Salesman stamp and signature, date of sale
