ACME LED-245 II User manual

User Manual
LED-245 II
Please read this user manual carefully and follow the instructions to
avoid danger or damage to the unit due to mishandling.
Thank you for purchasing our LED effect lighting, we guarantee your
satisfaction in having acquired this lighting product.
1-
A. SAFETY INTRODUCTIONS
•Please keep this User Manual for future consultation. If you sell the unit
to another user, be sure that they also receive this instruction booklet.
•Unpack and check carefully there is no transportation damage before
using the unit.
•Before operating, ensure that the voltage and frequency of power
supply match the power requirements of the unit.
•It’s important to ground the yellow/green conductor to earth in order to
avoid electric shock.
•The unit must be installed in a location with adequate ventilation, at
least 50cm from adjacent surfaces. Be sure that no ventilation slots are
blocked.
•Disconnect mains power before replacement or servicing.
•Replace only with the same type.
•Make sure there are not flammable materials close to the unit while
operating, as it is fire hazard.
•Use safety cable when fixes this unit.
•In the event of serious operating problem, stop using the unit
immediately. Never try to repair the unit by yourself. Repair carried out
by unskilled people can lead to damage or malfunction. Please contact
the nearest authorized technical assistance center and always use the
same type spare parts.
•Do not touch any wire during operation as high voltage might be
causing electric shock.

2-
B. TECHNICAL SPECIFICATION
Voltage: 230V~50Hz
Power consumption: 20W
LED : total 46pcs
- Red: 16pcs
- Green: 15pcs
- Blue: 15pcs
Fuse : T 2A
Dimension : 244 x 272 x 160mm
Weight: 3.2kgs
C. INSTALLATION
You can install the unit on the truss or ceiling, Use clamps to fix the unit to truss.
Always ensure that the unit is firmly fixed to avoid vibration and slipping while
operating. Always ensure that the structure to which you are attaching the unit
is secure. Also always use a safety cable that can hold 10 times of the weight
of the unit when installing the fixture.
D. TROUBLESHOOTING
Following are a few common problems that may occur during operation. Here
are some suggestions for easy troubleshooting:
A. The fixture does not work
•Check the connection of power and main fuse.
•Measure the mains voltage on the main connector.
B. No response to the sound
•Check microphone to see if it is good by tapping the microphone.
3-
Warnings
ÆAlways remember to unplug the unit from the main power before any service
is done.
ÆThere are no user serviceable parts inside.
ÆQualified personnel should do Service only.
ÆDo not touch any wires during operation.
ÆDo not touch the unit barehanded during operation.