Advantech PCM-26D1DB Installation and operation manual

STARTUP MANUAL
1 Startup Manual
1-Port Hilscher netX100 FieldBus mPCIe, PROFIBUS, DB9
2. Driver and Software Installation
Enter the Communication Solutions DVD in the PC and follow to the instructions of the installation wizard, to
install the driver.
Notes
For more information on this and other Advantech
products, visit our websites at:
http://www.advantech.com
http://www.advantech.com/eAutomation
For technical support and service:
http://www.advantech.com.tw/eservice
This manual is for PCM-26XXXX
Part No: 2003P20010 1st Edition
April 2015
1. Hardware Installation
PCM-26D1DB
2-Port Hilscher netX100 FieldBus mPCIe, EtherCAT, RJ45
2-Port Hilscher netX100 FieldBus mPCIe, EtherNet/IP, RJ45
2-Port Hilscher netX100 FieldBus mPCIe, Sercos III, RJ45
2-Port Hilscher netX100 FieldBus mPCIe, PROFINET, RJ45
2-Port Hilscher netX100 FieldBus mPCIe, POWERLINK, RJ45
PCM-26R2EC
PCM-26R2EI
PCM-26R2S3
PCM-26R2PN
PCM-26R2PL
This manual provides the brief steps of rmware installation. For more support documentation refer to the DVD
which included in the package from Hilscher.
a. Before beginning installation take the necessary safety precautions.
b. Open the cabinet of the PC or the connecting device.
c. Plug in and mount the cifx card.
d. Close the cabinet
e. Connect power to the PC or connecting device and switch it on.
2.2 SYCON.net Installation
Run SYCON.net-Setup and follow the instructions
of the installation wizard.
2.1 cifX Driver Installation
Click Install cifX / netJACK Device Driver

Startup Manual 2
3. Firmware Installation
Download Firmware and Configuration Use the
corresponding Master DTM in the configuration
software SYCON.net
3.1 Conguring Master using SYCON.net
Run SYCON.net and set the user password at the
rst-time login.
3.2 Conguring cifX (Master)
a. Congure the PC card cifX (Master)
b. Double-click the icon
3.3 Selecting the Driver
a. Click “Driver”
b. Select ”CIFX Device Driver” and “netXDriver”
c. Click "Apply"
3.4 Selecting "Device Assignment”
a. Click “Device Assignment”.
b. Click “Scan”
c. Select Device “CIFX 90E-R…”
d. Click “Apply”.
3.5 Firmware Download
a. Click “Firmware Download”
b. Click “Browse”(Disk:\Firmware\CIFX)
c. Select Firmware File.
d. Click "Download"