Akuvox R20A User manual

Allen wrench x 1
Rotary bracket x 1 ST4x20 screw x 4
Plastic wall anchor x 4
Mainframe Accessories :
Before you begin using the device, please check the version you got and ensure that the following
items are included in the shipped box:
Mark the four holes of the rotary bracket on
the wall.
Use a hand drill with 5mm diameter bit
to make the holes (20 mm in depth) in
the marked positions.
R20A/R20A-2
Torx wrench x1
Step1: Rotary Bracket Installaon
M4x10 screw x 4
M3x8 Torx screw x 2

Step2: Wall-mounng Bracket Installaon
Fix the rotary bracket onto the four plastics
wall anchors using four ST4 x20 screws, and
make sure the bracket is square to the wall.
Insert the four plastic wall anchors
into the four drilled holes.
R20A/R20A-2
Fix the the wall-mounting bracket onto the rotary bracket using four M4x10 screws.

AKUVOX (XIAMEN) NETWORKS CO., LTD.
ADD: 10/F, NO.56 GUANRI ROAD, SOFTWARE PARK II, XIAMEN 361009, CHINA
www.akuvox.com
Notice Information
R20A/R20A-2
Step3: Rotary Bracket Adjustment
Note: Please refer to R20A or R20A-2 quick guide to install the device back cover and to hang the device
on the wall-mounting bracket.
Fix the M3x8 Torx screws onto the rotary bracket
using the Torx wrench, then tighten the screws at
the appropriate rotary angle.
Installation completed.
Information contained in this document is believed to be accurate and reliable at the time of printing.
This document is subject to change without notice, any update to this document can be viewed on
Akuvox’ s website: http://www.akuvox.com © Copyright 2021 Akuvox Ltd. All rights reserved.