Argos Florenza 162/2377 User manual

162/2377
Assembly Instructions – Please keep for future reference
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
Issue 1 - 23/10/13
Florenza Bed
Dimensions (5')
Length - 210cm
Width - 155cm
Height - 115cm
5' KING
6' SUPER KING
183/8594
Dimensions (6')
Length - 210cm
Width - 185cm
Height - 115cm

1
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
• Check you have all the
components and tools listed on
pages 2 and 3.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Parts of the assembly will be
easier with 2 people.
• Make sure you have enough
space to layout the parts before
starting.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Dispose of all packaging
carefully and responsibly.
• Place the product on flat and
steady surface during use.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Keep these instructions for
further use.
• To ensure an easier assembly,
we strongly advise that all
fittings are only finger tightened
during initial assembly. Only
upon completion of the
assembly should all fixing points
be fully tightened.
Care and maintenance

Please check you have all the parts listed below
Components - Parts If you have damaged or missing components,
call the Customer Helpline: 08456 400800
2
Headboard panel (155 x 75cm - 5') (185 x 75cm - 6')
1
2Headboard post x 2
(45 x Ø3.8cm)
Footboard (155 x 75cm - 5') (185 x 75cm - 6')
Side rail x 2 (202.3 x 5.1cm)
4
3
End support x 2 (151.5 x 2cm - 5') (181.5 x 2cm - 6')
5
Central support (191.5 x 4cm)
6
8Wooden slat x 28
Support leg x 2
(27.3 x Ø2.5cm)
7

Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
If you have damaged or missing components,
call the Customer Helpline: 08456 400800
3
A
Rubber washer x 8
Plain washer x 20
Allen key x 2
B C
D E F
G
Nut x 8
35mm Allen screw x 4
25mm Allen screw x 4
13mm Allen screw x 8
Short stud x 2
HJ
K
40mm Allen screw x 4
L
Plastic cap x 14 Plastic cap x 28
Note:
Pre-assembled
onto slats.
Ruler - Use this ruler to help correctly identify the screws
0510 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170
Tools required
0
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150
1 2 345 6
Ruler/tape
measure

Step 1
Assembly Instructions
Step 2
Assembling posts
4
Place headboard panel
face down onto a
clean flat surface.
Note: Fixing holes for
posts should be facing
up.
Secure headboard posts
to headboard panel
using fixings
and .
A
2
1
B
1
Assembling side rails
a: With help, assemble
side rails to
headboard using fixings
and .
4
B C E
B D E
F
3
b: Assemble footboard
to side rails using
fixings and .
A
B
1
2
Back
Front A
B
1
2
BC
F
E
4
2
a:
DB
3
4
E
b:
a:
b:
4
4
3
2

Assembly Instructions
Step 3
5
Assembling slat
support frame
a: Assemble end support
to the underside of
side rails using fixings
and .
Repeat for both ends.
5
4
A B F
G
6
7
6
5
B H
c: Assemble central
support in between
end supports using
fixings and .
b: : Screw short studs
into the underside of
central support .
Screw support legs
onto the short studs and
tighten. a:
F
B
A
5
4
G
76
C:
B
H
5
6
7
G
b:
6
BH 5
6
4
4
5

Assembly Instructions
Step 4
Assembly is complete.
6
Attaching slats
a: Fit wooden slats
into the side rails as
shown.
Note: Plastic caps are
already pre-assembled
onto one end of wood
slats .
4
8
8
8
6
K
K
L
b: Fit wood slats into
both sides of plastic cap
, before pushing cap
into central support
.
6
8
8
8
4
a:
b:
K
L
K
8
8
L
L
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
Home Retail Group. 489-499 Avebury Boulevard. Saxon Gate West. Central Milton Keynes. MK9 2NW