Aseptico AEU-7P Manual

OPERATION and MAINTENANCE
INSTRUCTION MANUAL
AEU-7/AEU-7P Peristaltic Water Pump

SYMBOL DEFINITIONS:
Type B
Equipment
Dangerous
Voltage
Attention - Consult
Accompanying
Documents
TABLE OF CONTENTS:
ntroduction . . . . . . . . . . . . . . . . . . . . . . . . .1
Package Contents . . . . . . . . . . . . . . . . . . . .1
Setting Up the Unit . . . . . . . . . . . . . . . . . . .2
Operation Functions . . . . . . . . . . . . . . . . . .3
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Setup llustrations . . . . . . . . . . . . . . . . . . . .4
Sterilization & Maintenance . . . . . . . . . . . . .5
Troubleshooting . . . . . . . . . . . . . . . . . . . . . .5
Warranty . . . . . . . . . . . . . . . . . . .Back Cover
P.O. Box 1548
Woodinville, WA 98072
[phone]
[phone]
www.aseptico.com

1
Your new Aseptico Surgery rrigation Pump is one of the finest units available
to the medical profession. The system features a variable flow control, auto-
clavable tubing set, and on/off foot switch operation. These features combine
to make the perfect irrigation system.
Congratulations
This system is engineered to provide many years
of reliable service. Please read the instructions provided in this manual to
receive the best and longest service from your Aseptico equipment.
Separate manuals may be provided to cover the operation and maintenance
of other accessories for your unit.
PACKAGE CONTENTS
Electric Control Console
Power Cord
Autoclavable rrigation Tubing Set
Foot Control
rrigation Bag Hanger Rod
Operation Manual

2
SETTING UP THE UNIT:
1. Unpack the console and check that the voltage
is correct for the country of use. Use the 110V
for 110-120V 60Hz voltages, and the 220V for
220-250V 50Hz voltages. For alternative volt-
ages (220V- 250V), confirm that the type of plug
cap is correct for the country of usage and car-
ries the proper certification markings.
2. Plug the power cord from the back of the con-
sole into a grounded electrical receptacle.
3. Plug the foot control into the socket on the back
of the unit marked 'Foot Switch.'
IMPORTANT: Make sure the middle pin on the
foot control plug is oriented up (as shown)
before connecting to the Foot Switch socket.
4. nsert bag hanger rod into threaded hole on the
top of the unit. Thread into place about 1/4" and
secure with knurled lock nut.
5. Option l Pneum tic Activ tion -
(see picture on pg. 4) nsert tee fitting into drive
air side of foot switch or handpiece tubing on an
air type unit. Connect 1/8" tubing from tee fit-
ting to A R S GNAL barb located on the back
panel of the AEU-7 console. When power is on,
pump will operate simultaneously with drive air.
(20-150psi signal)
6. Option l AE-7DC Foot Control
(see picture on pg. 4) Connect one end to
footswitch connector on the pump and connect
the other end to either an Endo DTC unit or
Surgimotor unit for simultaneous operation.
TO HANDPIECE FROM BAG
BAG SPIKE
METAL CONNECTOR
THUMBSCREW
IRRIGATION TUBING SET
WARNING
Never connect or disconnect the b g spike to
the irrig tion b g over the console.
Any liquid spilled nd llowed to cont ct the
AEU-7/AEU-7P m y c use irreversible d m ge
nd will void the w rr nty.
BAG HANGER ROD
CONNECTION
AIR SIGNAL PORT

3
OPERATION FUNCTIONS:
1. POWER SWITCH - Controls power on/off
to console. When turned on, green L.E.D
on console should light up.
2. PUMP ON INDICATOR - Yellow L.E.D.
indicates pump in operation.
3. PUMP FLOW DIAL - ncreases or decreas-
es the irrigation flow. Turning dial clockwise
pump speed increases, thus increasing
fluid flow. Turning dial counterclockwise
decreases flow. Flow range is from 0 to
60ml per minute.
4. FOOT SWITCH - Activates pump rotation
when unit is turned on and foot switch is
attached.
OPERATION:
After the unit has been set up and you have
made yourself familiar with the operation func-
tions, you are ready for operation as follows:
1. Turn the power switch on the lower left front
of the console to the 'ON' position. The
power display will light.
2. Route a sterile tubing set through the pump,
as illustrated on pg. 2, and attach the appro-
priate output device for the procedure being
performed.
3. Depress the foot switch to start pump opera-
tion. The pump on L.E.D. should light to indi-
cate operation.
4. Adjust the flow dial for desired irrigation flow
level.
PUMP ON
INDICATOR
POWER
SWITCH
PUMP FLOW
DIAL
POWER
FLOW
SURGICAL
IRRIGATION SYSTEM

4
AEU-7 with AE-7 On/Off Foot Switch
SETUP ILLUSTRATIONS
Option l AE-7DC Foot Switch
Allows for oper tion of both the
AEU-7 pump nd either the Endo
DTC or SurgiMotor II electronic
rot ry systems.
AEU-7P connected to AEU-17B or AEU-25 with AE-60 for
ctiv tion with Pneum tic Foot Control

5
Problem:
Console does not light when
turned on:
Console lights when turned on,
but pump rotor does not turn:
No water flow from pump to out-
put needle:
Correction:
Check console to power connection.
Check that voltage is correct for unit.
Check fuse. f blown, replace with .5A/250V fuse.
Depress foot switch to activate.
ncrease flow control.
Check pump tubing for any binding or improper
installation.
Check Air Signal if used.
Check that pump is on and flow level is sufficient.
Check that the water container seal is completely
punctured.
Make sure the irrigation tubing is properly installed
in the pump and is in the correct direction.
TROUBLESHOOTING:
STERILIZATION & MAINTENANCE:
IRRIGATION TUBING SETS - The irrigation tubing sets can be removed from the pump and
may be sterilized by autoclave, chemclave, or ethylene oxide gas processes. Follow the man-
ufacturer's recommended procedure. The entire tubing set should be sterilized after every
patient use. Remember to remove the bag of irrigation from the bag hanger rod before
removing the tubing set.
NEVER store the tubing sets in the pump for extended periods of time. The tubing may col-
lapse and stick to itself creating a blockage for future uses.
Any external surfaces of the AEU-7 unit that are contacted during use should be carefully
wiped down with disinfectant after every patient and at the beginning of each day.

P/N: 420325
Rev. C
ECO 14121
04/2017
P.O. Box 1548 • Woodinville, WA 98072
8333 216th Street SE • Woodinville, WA 98072
[phone] • [phone]
www.aseptico.com • [email protected]
WARRANTY
Aseptico warrants its products against defects in material or workmanship for a
period of one (1) year, from date of original invoice. Some handpieces are warranted
for one year under the same conditions. Other handpieces and expendable
components, such as air turbines and light bulbs, are covered by shorter warranty
periods, or have no warranty. Aseptico's sole obligation under product warranty is (at
its sole option and discretion) to repair or replace any defective component or product
in part or whole. Aseptico shall be the sole arbiter of such action.
n the event of alleged defect under warranty, the purchaser is to notify Aseptico's
Customer Service Department promptly. Customer Service will provide instructions,
usually directing that the product be returned for service. Shipment to Aseptico and
the cost thereof is always the responsibility of the purchaser.
Accidental misuse, inappropriate installation, or failure to perform directed
maintenance voids the warranty.
Aseptico does not assume, under this warranty, any risks or liabilities arising from the
clinical use of its products, whether or not such use involves coincidental utilization of
products manufactured by others.
NOTE: n the interest of serving our customers more efficiently, customers receiving
service on non-warranted repairs are expected to accept charges that are less than
$250.00 without further notification.