Assa Abloy Lockwood CAVITY LOCK User manual

Drill Ø2mm pilot hole squarely
through the door.
.
CAVITY LOCK®
Sliding Door Furniture
Backset 60mm
Fold here on door edge
Template
CL
1
2
Door and pull preparation template
Passage Set door preparation and pull installation (steps 1 - 9)
Fold here on door edge
1
6
2
7
3
8
4
9
5
1300 LOCK UP
lockweb.com.au
Please ensure that all necessary safety precautions are taken when installing this product.
Q50048 C 0516
ASSA ABLOY Australia Pty Limited, 235 Huntingdale Rd, Oakleigh, VIC 3166 ABN 90 086 451 907 ©2016
Chisel out recess to suit face
plate. Face plate must be flush
with door face.
Insert pull into recess.
Mark and drill 2mm pilot holes,
and ax with screws provided.
Press the retractable door pull
button to release it.
(Press it to reset).
Pull on the retractable door pull
to remove door from cavity.
Insert pull into Ø25mm hole,
mark around latch face plate.
1. Drill Ø25mm pull hole to depth
of 70mm, ensure hole is
drilled squarely.
2. Drill a Ø54 furniture hole,
from both sides of door to
prevent splintering.
1. Find centre of door edge
and mark ready for drilling
Ø25mm pull hole.
2. Mark hole position ready for
drilling Ø54 furniture hole,
both sides of door.
Mark line on the door face
approximately 900mm from
the floor. Tear along perforated
line on template. Fold page
along --- dashed line and place
fold on door edge. Align CL with
marked line on door face.
Important Note
Drill hole from both sides of door
to prevent splintering of the door face.
Mark hole
position ready
for drilling
Ø54mm
furniture hole.
Find centre of
door edge and
mark ready for drilling
Ø25mm latch hole.
Tear along perforated edge
Tools Required
- Ø54mm Hole saw
- Ø25mm Spade bit
- Ø2mm Drill bit
- Power drill
- 25mm Chisel
- Pencil
- Ruler or tape measure
- Phillips head screw driver
32MM - 45MM
DOOR THICKNESS
INSTALLATION OF
PASSAGE SET
Status Approved 2016-05-16

CAVITY LOCK®
Sliding Door Furniture
32MM - 45MM
DOOR THICKNESS
INSTALLATION OF
PASSAGE SET
Slide door using finger grip.
Mark around strike plate.
Drill 2mm pilot holes.Affix with screws provided.
Passage set installation (steps 10 - 15)
Passage set strike installation (steps 16 - 21)
10
16
20
14
11
17
21
15
12
18
13
19
Screw sizes for Door Thickness:
32mm-40mm Use 25mm Screw
40mm-45mm Use 35mm Screw
Trilobe screw (Thread forming
screw)
Furniture assembly. Assembly shows both sides
interlocking.
Assemble as shown with screw
holes vertical.
If door is less than 33mm thick
use packers. Fit the packers to the
inner faces of the furniture,
against the door face.
Mark a horizontal line on the door
(this line passes through the
centre of the 54mm hole).
Extend this line along the face
of the door jamb.
Align the pip on strike plate with
the line on the jamb (horizontal)
Align the pip on the strike plate
with the centre of the pull button
(vertical).
Chisel out recess for strike plate.
Strike plate must be flush with
door jamb.
Status Approved 2016-05-16