Ballard Designs SL119 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 7/5/18 Page 1 of 4
PRODUCT NAME: Chianni Trestle Table
ITEM NUMBER: SL119
DIMENSIONS OF ITEM ASSEMBLED: 30.5“ H x 84.25”W x 36”D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Ltr.
A 8 Large Bolts
B 8 Small Bolts
C 2 Stacking Plates
D 16 Flat Washers
E 16 Lock Washers
F 1 Allen Wrench
Qty. Hardware Included Ltr. Qty. Hardware Included
Ltr.
G
Top (G)
Leaf (H)
Legs (I)
Stretcher (J)
1
H 1
I 2
J 1
Qty. Components
TOOLS NEEDED:
-Two person assembly
suggested.
NOTE: When unpacking, lay
the parts on a padded surface
such as the packaging provided.
Be sure to locate all hardware
before throwing away any
packaging.
(G)
(H)
Hardware Located
Here
(I)
(J)
Instructions

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(F)
(E)
(D)
(C)
(B)
(I)
(I)
(J)
(J)
STEP 1: Turn the Legs (I) so the bottom faces upward. Insert the dowels located on the ends of
the Stretcher (J) into the holes on the Legs.
Attach the Stacking Plates (C) to the bottom of the Legs (I) and Stretcher (J) using the
Small Screws (B), Lock Washers (E), and Flat Washers (D). Tighten using the Allen
Wrench (F). If the unit appears uneven, adjust the levelers on the bottom of the Legs
until the unit appears even.
STEP 2:

(G)
(F)
(E)
(D)
(A)
(I)
Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 3: Turn the Legs (I) upright and attach them to the Top (G) using the Large Screws (A),
Lock Washers (E), and Flat Washers (D). Tighten using the Allen Wrench (F). When
needed, the Leaf (H) can be inserted or removed by sliding the two sides of the Top
apart and aligning the dowels in the Top with the holes in the Leaf.
NOTE: Avoid moving the table after it is assembled to prevent injury or destruction.
(H)