Ballard Designs Ananda MS114 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 12-15-2020 Page 1 of 4
PRODUCT NAME: Ananda Serving Table
ITEM NUMBER: MS114
ASSEMBLED DIMENSIONS : 33”H x 81 1/2”W x 12”D
MADE IN CHINA
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 4
Ltr.
A
4
B4
Qty. Hardware Included
Ltr.
D
E1
2
Qty. Components
C1
REQUIRED TOOLS:
Phillips Screwdriver,
Allen Wrench (included)
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
Allen Bolts
Flat Washers
Allen Wrench
2
Wall Anchoring
(Anti-tip) Kits
See page 4
F
G
H
2
2
WARNING
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
ANCHORING HARDWARE INCLUDED
Top (E)
Leg (F)
Bracket #1 (G)
Bracket #2 (H)
Assemble in location for intended use.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Cleaning and Care
Periodically dust with a soft, dry cloth.
Protect surfaces to prevent damage.
Do not use alchohol based cleaners or polishers.

Page 3 of 4
STEP 1: Invert Top (E) onto a clean, soft, level surface then insert Brackets (G,H) as illustrated below.
NOTE: Brackets #1 and #2 must be installed opposite one another on the same end.
STEP 2: Carefully align each Leg (F) between Brackets (G,H) then attach by inserting Allen Bolt (A)
with Flat Washer (B) and firmly tightening using Allen Wrench (C).
(A)
(B)
(F)
(G)
(H)
(G)
(H)
(E)
(C)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 4 of 4
Installation:
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
R
e
presen
t
a
tiv
e
Fu
r
nitu
r
e
I
tem