Ballard Designs MI442 LRG User manual

MADE IN CHINA
Page 1 of 3

3
3Tap Head Screw
Wall Anchor
Mounting Cleat
Required Tools:
Phillips Screwdriver
Drill
Level
Large Drying Rack
Page 2 of 3

STEP 1: Determine exact location of Drying Rack on wall. Using a level, place Mounting
Cleat (C) in desired location and use a pencil to mark three holes. NOTE: At least two
(preferably all) screws must be driven into a stud. Use a drill to create small holes in
drywall and insert an Anchor (A) into the open drywall holes, but NO hole or anchor over a
stud.
STEP 2: Align holes in Mounting Cleat with Anchors and stud(s) and use Tap Head Screw
(B) to secure cleat to wall. Firmly tighten.
At least two screws must
be mounted into a wall stud.
STUD
STUD
Step 3: Gently lift and hang Drying Rack on Mounting Cleat (C) by hooks mounted on
each end of the Drying Rack.
Page 3 of 3
No Anchor
No Anchor