Ballard Designs CASA Florentina Caprice Pedestal Table User manual

800.367.2810
PRODUCT NAME:Caprice Pedestal Table
ITEM NUMBER: TD316
DIMENSIONS OF ITEM ASSEMBLED:
30”H x 44”Diam.
Check to ensure that you have the following:
Hardware Included
.ytQ.rtL
A 4
B 4
Part List
.ytQ.rtL
G
H
J
I
4
1
1
1
Legs
Top
Wood Top Plate
Middle Shaft
C 5
D 5
E 4
Bolts
Small Washers
Large Washers
Nuts
Long Screws
F 1 Tool
www.ballarddesigns.com
For Assembly Purposes:
-Requires 2 people.
-Requires a screwdriver.
This item is not intended for commercial use.
Made in Italy.
Page 1 of 3
2010 Ballard Designs, Inc.

STEP 1:Leg Installation
Insert the first Leg (G) into the bottom of the Middle Shaft (I). Then using the Tool (F)
take a Large Washer (C) and Nut (D) and tighten them on the pre-installed bolts
inside of the Middle Shaft. Repeat this step for all 4 Feet (G).
(G)
(E)
(D)
(D)
(C)
(C)
(I)
STEP 2:Top Plate Installation
After installing all 4 legs, flip the table onto its legs and lay the Wood Top Plate (J).
Align the plate with the Middle Shaft (I). Then tighten a Large Washer (C) and Nut (D) onto
the center bolt. Finally secure the Plate with 4 Long Screws (E).
(J)
800.367.2810
www.ballarddesigns.com
Page 2 of 3
2010 Ballard Designs, Inc.

STEP 3: Table Top Installation
Lay table Top (H) upside down without removing the protective wrapping.
Then place the table base assembled in STEP 2 and secure it to the Top using Bolts (A)
and Small Washers (B). Secure all 4 corners with the Tool (F).
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as they can damage the finish.
Dust with soft cloth. One to two times monthly apply beeswax polish as needed.
Finish can be affected by heat or extended contact with oils or wine.
Page 3 of 3
2010 Ballard Designs, Inc.
800.367.2810
www.ballarddesigns.com
(H)
(B)
(A)
(B)
(A)
(B)
(A)