Ballard Designs Taylor Media Tower MQ131 User manual

REQUIRED TOOLS:
Phillips Screwdriver, Flat Blade Screwdriver (levelers)
-Two person installation suggested.
Ltr.
A2
B12
Qty. Hardware/Components Included
Wall Anchoring
(Anti-tip) Kits
See page 3
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
C4
D2
E1
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 11-17 -2021 Page 1 of 3
PRODUCT NAME: Taylor Media Tower
ITEM NUMBER: MQ131
ASSEMBLED DIMENSIONS : 82”H x 34”W x 17”D
MADE IN CHINA
(C)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Shelf Supports
Upper Shelves
Wooden Plugs
Lower (narrow) Shelf
LEVELERS: Tower is equipped with Rotary Levelers under each corner which are accessible from
INSIDE cabinet. 1. Insert screwdriver through hole in corner, adjust Leveler by turning clockwise/counter-
clockwise. 2. Cover hole with Wooden Plug (C)
1
2

REVERSIBLE DOOR: Change door swing (left/right) by using a Phillips Screwdriver to remove metal
Catch Plate, Magnet, Door Pull, and inside compartment, hinge connections. Move all hardware to
reversed positions and replace screws. See diagram below.
(E)
Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alcohol based
cleaners or polishers. Promptly remove spills.
Page 2 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
SHELVES: Insert Shelf Supports (B) into pre-drilled holes in upper compartment of Tower. Carefully set
Upper Shelves (D) level upon Supports. Next, insert Shelf Supports (B) into lower compartment then set
Lower (narrow) Shelf (E) level upon Supports.
(B)
(E)
Assemble in location for intended use.
(B)
(D)
(D)

Page 3 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Installation:
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
Representative Image
Not meant to be actual item included with
these instructions.