Ballard Designs Mia MS102 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 11-26-2019 Page 1 of 4
PRODUCT NAME: Mia Cabinet
ITEM NUMBER: MS102
ASSEMBLED DIMENSIONS : 34”H x 35”W x 16”D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Ltr.
A4
B 1
Qty. Hardware Included
Ltr.
C
D
1
1
Qty. Components
REQUIRED TOOLS:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
Shelf Supports (A)
Wall Anchoring
Anti-Tip
Hardware (B)
Shelf & Hardware
Located Here
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
Cabinet (C)
Shelf (D)
NOTE: Assemble Cabinet in location for use.

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Determine height for Shelf (D) then insert Shelf Supports (A) into corresponding pre-drilled
holes.
(D)
(A)
LEVELERS: Cabinet is equipped with Rotary Levelers under each corner. If necessary, Cabinet
may be leveled by gently lifting a corner and turning levelers clockwise/counterclockwise.

Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Installation:
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as
they can damage the finish. Dust with soft cloth.
Ltr.
A2 Small Screw
Retention Belt
Qty. Hardware Included
B2 Large Screw
C4 Bracket
D2
HARDWARE PART B: ANCHORING HARDWARE (ANTI-TIP)
1. Locate and mark a Wall Stud behind unit at location for installation.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
W
A
L
L
S
T
U
D
WALL BRACKET MUST BE ATTACHED TO WALL STUD
B
ack
of
F
urn
i
tureI
t
em
Serious or fatal crushing injuries can occur from a furniture tip-over
WARNING
Tip-Over Hazard
WALL BRACKET MUST BE ATTACHED TO WALL STUD
Prevent tipping accidents. Anchor your furniture.