Ballard Designs Dehavilland SF080 User manual

Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 3-25-2021 Page 1 of 4
PRODUCT NAME: Dehavilland 3 Door Sideboard
ITEM NUMBER: SF080
ASSEMBLED DIMENSIONS : 35 1/2”H x 61”W x 17 3/4”D
MADE IN CHINA
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 4
REQUIRED TOOLS:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
Ltr.
A 4
B2
Qty. Hardware Included
Shelf Supports
Wall Anchoring
Anti-tip Kits
See page 4
Ltr.
D
E
4
1
Qty. Components
C1
NOTICE: Hardware Packet and Shelf
ship attached underside Sideboard.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
Sideboard (C)
Shelf (E)
*Legs (D)
Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alchohol based
cleaners or polishers. Promptly remove spills.
*Legs shipped boxed inside drawer.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Assemble in location for intended use.

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Invert Sideboard (C) onto a level, padded surface and insert a Leg (D) into embedded T-nuts in
each corner. Hand tighten until firmly secured then turn Sideboard upright.
Do not place uneven pressure on Legs as Sideboard is turned upright.
(C)
(D)
STEP 2: Determine location for Shelf (E) then insert Shelf Supports (A) into corresponding pre-drilled
holes. Gently place Shelf level upon supports.
(A)
(E)
Assemble in location for intended use.

Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Installation:
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
R
e
presen
t
a
tiv
e
Fu
r
nitu
r
e
I
tem