Ballard Designs Original Home Office Craft Station MO528 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 11-19-2020 Page 1 of 4
PRODUCT NAME: Original Home Office Craft Station
ITEM NUMBER: MO528
ASSEMBLED DIMENSIONS : 38 3/4”H x 49 1/2”W x 30”D
IMPORTED
TM
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.

Page 2 of 4
TOOLS REQUIRED:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
Assemble in location for intended use.
Ltr.
C
Qty. Components
1
Cabinet (C)
Ltr.
A4
B2
Qty. Hardware Included
File Drawer Rails
*Wall Anchoring
(Anti-tip) Kits
See Page 4
Hardware
Here
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alchohol based
cleaners or polishers.
*This Wall Anchoring Hardware IS NOT USED if attaching OHO Craft Station Hutch (sold separately).
Refer to Assembly Instructions included with Hutch for approved anchoring hardware and installation.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Assemble in location for intended use.
Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Cabinet (C) is equipped with Rotary Levelers installed under each corner. To adjust, set Base
into place then carefully lift applicable corner and turn Leveler clockwise/counterclockwise.
STEP 2: Open both lower drawers and insert File Drawer Rails (A) into notches in top edge of drawer.
(C)
(A)

Installation:
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
This Wall Anchoring Hardware IS NOT USED if attaching OHO Craft Station Hutch (sold separately).
Refer to Assembly Instructions included with Hutch for approved anchoring hardware and installation.
N
O
T
E
Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com