BDI Icon 9422 User manual

Base
E x 2
F x 4
H x 1
G x 1
B x 12
C x 18
D x 31
A x 8
Hardware list:
K
J x 1
I x 1
M x 2
ICON is a trademark of
Becker Designed Inc. All
rights reserved.
Patents pending
©2004 Becker Designed Inc.
x 7 of each
L
Your ICON home theater furniture is engineered for easy assembly. Carefully follow this procedure to prevent
any damage. Assembly should be done on a clean non marring surface. All tools necessary are provided. Icon
is designed for indoor use on level surfaces. Clean glass parts with glass cleaner, clean steel and wood parts
with a moist cloth. If any parts are damaged or missing please contact BDI at [email protected]
Designed by : Cristian Wicha & Bill Becker
Component list:
Glass shelves x 5
Shelf
brackets x 12
Front Frame
Assembly Instructions
Icon 9422
Back
panel
Glass top
C-Frame
HIGH PERFORMANCE
FURNITURE FOR YOUR
HOME THEATER

Step 2
Install frame onto base.
Use shown hardware to attach base to
frame.
Base is easiest to install if unit
is turned upside down.
Install Levelers x 4
Adjust Levelers so base is level and
stable.
F
x 4
J
H
G
A
x 2
I
x 4
D
x 2
Step
1a x 2
.
E
Step 1a + 1b
Install the C-frame.
1a
Attach mounting plate to the upper and lower
ends of C-frame.
1b
Attach C-frame oriented properly, (Bottom of
C-frame has 2 holes and top of frame has 1 hole)
J
J
Step
1b
.

I
Step 4
Install the Shelf brackets.
Shelf brackets can be adjusted to
offer two different shelf positions for
each shelf.
Note: to reposition Shelf brackets it
is not necessary to remove the back
panel.
J
D
x 12
brackets
D
x 3
J
D
Step 3
Install Back panel.
Back panel is to be installed with small
holes facing backward. BDI label
should be on bottom left corner of
Back panel.
Wire management straps.
Velcro straps are supplied to control
cables. They can be screwed into the
small holes on the back panel in
location desired.
L
K

Use 3 x C
Bottom Shelf Glass:
Use 3 x A
Step 5
Install Glass shelves.
Use appropriate hardware. Apply
Felt washers to the stainless pucks
prior to glass installation.
PLEASE READ:
leave glass screws loose
until all screws have been
installed.
Then tighten securely.
It may be necessary to loosen shelf
brackets to obtain proper fit. Once
Glass Shelves and Top are fitted,
Please be certain to go back and
tighten all screws!
Shelf Glass:
Use 3 x B
Use 3 x C
Top Glass:
Use 3 x C
Use 3 x A
Becker Designed Inc.
14101-A Parke Long Ct
Chantilly VA 20151
www.bdiusa.com