BDI STANCE MODESTY PANEL 6657 User manual

Designed by BDI Studio
These distinctive product configurations are protected by US and international patents, trade dress, and/or
copyright laws. Stance & BDI are trademarks of Becker Designed, Inc. All rights reserved. ©2019, BDI
Made in Turkey. 06.20.2019
Modesty Panel x 1
Brackets x 2
bdiusa.com
[e-mail]
STANCE®6657
MODESTY PANEL
Tool Required:
Phillips screwdriver
Hardware List:
Product Registration
Registering your new BDI product allows us to send you important product
updates, service information and helpful hints related to your BDI products.
Register today, and you will be entered to win free a BINK table from BDI:
www.bdiusa.com/register
Placement and Maintenance
Stance®Lift Desk is designed for indoor use on level floors. Clean wood
veneer with a damp cloth.
Your Stance®Office furniture is engineered for easy assembly. Carefully
follow this procedure to prevent any damage. Do not use power tools
for assembly of this product.
Step 1
Unpack and identify the parts listed below. The assembly workspace should
be a non-marring surface such as carpet. For missing hardware pieces,
please contact BDI Customer Service at [email protected].
For all other concerns, please contact your BDI retailer.
H1 Wood Screw x 8
H2 M6 x 12 Screw x 2

bdiusa.com
[e-mail]
STANCE 6657
MODESTY PANEL
2
Step 1 - Install the brackets
Attach the 2 metal brackets to the modesty panel as shown with the 8 wood screws provided going into the
8 pilot holes located towards the top, inside edge of the panel. Tighten with a Phillips screwdriver.
DO NOT use a power drill.
DO NOT over tighten the screws, otherwise they will strip.
Phillips screwdriver
H1 Wood Screw x 8

bdiusa.com
[e-mail]
STANCE 6657
MODESTY PANEL
3
1) Insert screws half way
2) Slide bracket notch
backwards and onto
screw heads
3) Tighten screws with
hex wrench provided
Step 2 - Install the modesty panel
Find the 2 threaded holes on either side of the metal tray. Thread the screws H2 half way into the threaded
holes. Hook the modesty panel onto the screw heads, slide backward and then tighten the 2 screws with the
hex wrench provided.
Bracket notch
Metal Tray
H2