Black Box ME444A-530-R3 User manual

1
Black Box Corporation • 1000 Park Drive • Lawrence, PA 15055-1018 • Tech Support: 72 -7 6-5500 • www.blackbox.com • e-mail: [email protected]
12/2/200 #15035
© 200 . All rights reserved.
Black Box Corporation.
Selectable speeds
range up to 256 kbps.
Your choice of
interfaces in desktop
or rackmount card
models.
Built-in BERT supports
.54 loop diagnostics.
Includes conditioned
diphase modulation.
Runs in full or
half-duplex mode.
S
end data at speeds up to
256 kbps on twisted-pair wire
over long distances with the
LDM-MR256. It supports
transmission distances of up to
3 miles ( .8 km) on 19 AWG wire
or 2 miles (3.2 km) on 2 AWG
wire at top speed. Longer
distances are possible at slower
speeds.
A built-in Bit Error Rate Tester
(BERT) tests both the line drivers
and the line.
As a bonus, the line driver
includes V.5 diagnostic
capabilities. You can perform
local and remote loopback tests
Send data at high speeds over long
distances with these line drivers.
KeyFeatures
256-KBPSLINEDRIVERS
Ordering Information
ITEM CODE
256-kbps Line Drivers (LDM-MR256)
Desktop Models
V.35...................................................................ME A-R3
RS-530.....................................................ME A-530-R3
Rackmount Cards
V.35 ...................................................................ME 5C-35
RS-530............................................................ME 5C-530
To rackmount your modems and cards, order…
RackNest 2/1
115-VAC ....................................................................RM110A
230-VAC..................................................................RM110AE
Clocking: Internal, external,
recovered
Operation: -wire half- or full duplex
Protocol: Asynchronous and
synchronous
Speed: Up to 256 kbps
Interface:
ME A-R3, ME 5C-35: V.35;
Interface (continued):
ME A-530-R3, ME 5C-530:
RS-530
Power: ME A models: 115 VAC;
ME AE models: 230 VAC;
ME 5C models: From the
RackNest 2/1
Size: ME A-R3, ME A-530-R3:
1.6"H x 9.6"W x 7.6"D ( .1 x
2 . x 19.3 cm);
RM110A, RM110AE: 7"H x 19"W x
10. "D (17.8 x 8.3 x 26. cm)
Weight: ME A-R3,
ME A-530-R3: 3.1 lb. (1. kg)
Specifications
from the device’s front panel—
or via control signals from the
interface connector.
With the LDM-MR256 your
data is safe, too, thanks to
conditioned diphase modulation.
This feature provides background
noise immunity, gives you efficient
data transmission and reception,
and eliminates normal line
distortion.
NOTE: These line drivers must be
used in pairs.