brel-motors MGS-45 User manual

Page 1
BREL motors is part of:
Manual Brel for standard curtaintrack motor
Type MGS-45
Read the manual before you begin the installation. f these instructions are not followed,
this may lead to defects and injury in which warranty can’t be claimed.
warning:
Children cannot recognize the dangers of electrical equipment and may therefore not work with it
t is important to follow this instruction for your own safety.
1 Do not operate the motor in humid surroundings
2 The motor must be installed correctly
3 Keep the antenna in a good condition and do not shorten The antenna should not come into contact with other
metal parts otherwise it will reduce the effect
4 The motor must be protected from direct moisture influences
_______________________________________________________________________________
Functions wall switch
_____________________________________________________________________________
Technical data of the motor Type MGS45
 Motor Voltage: 230V
 Power: 45 Watt
 Speed: 12 rpm
 Max curtain weight: 40 kg
 Ampèrage 0 23 A
 Max duration: 4 min
 Moisture and dust: IP40
 Working temperature of the motor:
o Normal use: -10℃ tot +40℃
o Heavy use: -20℃ tot +70℃
_______________________________________________________________________________
Functions
LED
P1 Programmbutton
Connection for switch

Page 2
_______________________________________________________________________________
Wiring chart
.
_______________________________________________________________________________
nstallation motor and rail
Attach the rail to the wall / ceiling
Mount the rail not vertical.
f the motor don’t want to click easily, turn the gear wheel a bit and try again.
_______________________________________________________________________________
Setting the end positions Operate the motor for the first time and it automatically searches the end positions.
1x 

|

 

 

 1x 

|

 

 


Press the open button The curtain opens completely Press the close button The curtain closes completely
DO NOT press STOP! and stops hard at the end and stops hard in the middle
If the end positions are set with a hard stop, the curtain will stop 1 cm before the end in the future.
_______________________________________________________________________________
Cancel end positions Go to previous action to automatically reset the end positions.
Hold down P1 LED will light up for a long time Release when the LED flashes and goes out