brel-motors MR45-20 User manual

Page 1
BREL motors is part of:
Manual Brel 45mm standard radio motor
Type MR45
Read the manual before you begin the installation. If these instructions are not followed,
this may lead to defects and injury in which warranty can t be claimed.
warning:
Children cannot recognize the dangers of electrical equipment and may therefore not work with it
It is important to follow this instruction for your own safety.
1 Do not operate the motor in humid surroundings
2 The motor must be installed correctly
3 Keep the antenna in a good condition and do not shorten The antenna should not come into contact with other metal parts
otherwise it will reduce the effect
4 The motor must be protected from direct moisture influences
5 The motor should be installed with the motor cable down in order to prevent moisture via the motor cable is running in the
motor See Figure 1
6 It is prohibited to connect two motors on a switch without using a relay control Figure 1
______________________________________________________________________________
Technical data of the motor Type MR45-20 Type MR45-40
• Motor Voltage: AC 230V AC 230V
• Power: 145 Watt 198 Watt
• Torque: 20 Nm 40 Nm
• Speed: 15 rpm 15 rpm
• Ampèrage: 0 64 A 0 86 A
• Moisture and dust: IP44 IP44
• Working temperature of the motor:
o Normal use: -10℃ tot +40℃
o Heavy use: -20℃ tot +70℃

Page 2
_______________________________________________________________________________
Reach Wiring chart
L1 = 100 meter L2 = 25 meter
_______________________________________________________________________________
Installing the motor
Attach the crown and wheel to the motor and place the clip on the shaft of the motor so that the wheel
is fixed to the motor
Install the motor with the motorbracket on the product and take care that it is secured
Place the motor in the tube of the roller/shutter
(These assemblies are usually already done in the factory)
Adapter
_________ Wheel
_______________________________________________________________________________
Setting the end limits of the motor
To determine where the motor must stop, you must use the supplied adjustment pin
The large arrow indicates in which direction you change the end limits
By turning to the Plus or Minus you can change the end limits
By turning to the Plus, the motor will make more rotations
By turning to the Minus, the motor will make les rotations
The setting needs to be done for both directions of rotation
If the motor is stopped by it selves, do not make more than one rotation to the Minus
This can disrupt the adjustment

Page 3
_______________________________________________________________________________
Step 1 Setting up the first channel
2x P2 Press the button up
The motor turns left
Press the button down
The motor turns right
Turn the power on Press 2x on the P2 button,
within 3 sec
If you have made the wrong choice in the above, you can again follow the described procedure.
You should turn of the power more than 3 seconds. to enter the programming mode. The above procedure also
makes the memory empty, all the old programming will be removed.
_______________________________________________________________________________
Step 2 Teaching multiple transmitters (Up to 20 transmitters per receiver)
2x P2 1x P2
Press P2 button 2x Press P2 button 1x Programming the new
of the existing transmitter of the new transmitter is ready
transmitter or channel
To delete one channel , you must repeat the above operation.
_______________________________________________________________________________
Step 3 Reset all
1x P2 1x STOP 1x P2
Press P2 button 1x Press stop button 1x Press P2 button 1x All channels are removed
_______________________________________________________________________________
Step 4 Pulse setting
1x 1x 1x
The motor is ready for use
Press P1 button 1x Press up button 1x Press down button 1x
To remove the pulse setting, repeat the above operation.