BROSA Elizabeth Console Table User manual

ASSEMBLY GUIDE
Elizabeth Console Table
v1.0

Components
Upon unpacking your console table from its delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new console table.
Table top x 1
Shelf x 1
Leg x 2
Leg x 2
Hardware
What you need
A x 4
Spec: M8 x 40mm
B x 4
Spec: Ø8.4 x 2mm
C x 4
Spec: Ø8.4 x 17 x 1.6mm
E x 4
Spec: Ø7 x 49.5mm
F x 4
Spec: Ø8 x 8.5mm
D x 1
Spec: M4

Step 1 Insert a steel dowel (E) into the hole in each leg (3 & 4)
making sure that it is facing the correct direction.
E x 4
Step 2 Align a leg (3) to the underside of the table (1). Fit a
lock washer (B) to a bolt (A) followed by a at washer
(C) and screw into the hole using the allen key (D) to
tighten in place.
A x 1
B x 1
C x 1
D x 1

Step 3 3.1 Align the shelf (2) to the structure formed in Step 2
making sure the steel dowel (E) protruding from the
leg (3) ts into the shelf (2). With another person
holding the shelf (2) align a leg (3) to the underside of
the table (1) and the shelf (2). Fit a lock washer (B) to a
bolt (A) followed by a at washer (C) and screw into
the hole using the allen key (D) to tighten in place.
3.2 Insert a grub screw (F) in both holes and secure in
place using a pozi screwdriver.
Step 3.1
Step 3.2
A x 1
B x 1
C x 1
D x 1
F x 2

Step 4 4.1 Align a leg (4) to the underside of the table (1) and
the shelf (2). Fit a lock washer (B) to a bolt (A) followed
by a at washer (C) and screw into the hole using the
allen key (D) to tighten in place. Repeat the process for
the other leg (4).
4.2 Insert a grub screw (F) in both holes and secure in
place using a pozi screwdriver.
Step 4.2
Step 4.1
A x 2
B x 2
C x 2
D x 1
F x 2