BROSA Elizabeth Entertainment Unit User manual

ASSEMBLY GUIDE
Elizabeth Entertainment Unit
v1.0

Components
Upon unpacking your entertainment unit from it’s delivery box, you should
have the separate pieces shown below. Follow the steps on the next pages to
assemble your new entertainment unit.
Entertainment
unit x 1
Shelving x 2 Shelving x 2
Leg x 2
Leg x 2
Hardware
What you need
A x 4
Spec: M8 x 12 x 30mm
B x 4
Spec: M8 x 60mm
C x 4
Spec: Ø8.4 x 17 x 1.6mm
D x 4
Spec: Ø8.4 x 2mm
E x 4
Spec: M8 x 13
F x 1
Spec:
G x 16
Spec:

Step 1 1.1 Insert a cross dowel (A) in the top hole on each leg
(2 & 3) making sure that it ts facing the correct
direction as shown in the diagram.
1.2 Insert a threaded bolt (B) in the side hole on each
leg (2 & 3) twisting it to secure in place.
Step 1.1
Step 1.2
A x 4
B x 4

Step 2 2.1 Align each leg (2 & 3) one by one to the underside
of the entertainment unit (1) so that the threaded bolt
(B) ts in its corresponding hole.
2.2 Fit a washer (C) to the threaded bolt (B) followed by
a lock washer (D) and a nut (E). Use the spanner (F) to
tighten the nut (E) securing the leg in place. Repeat
process for the remaining legs (2 & 3).
Step 2.1
Step 2.2
C x 4
D x 4
E x 4
F x 1

Step 3 3.1 With another person, gently lift the entertainment
unit and place it upright on a level surface. On the
inside of the entertainment unit insert the shelving
supporters (G) at the desired level, making sure that
the pin on each of them are facing upward.
3.2 Angle the shelves when inserting (one by one)
making sure the holes are facing down so that the pins
of the shelving supporters (G) t inside securing the
shelves in place.
Enjoy your new entertainment unit!
G x 16
Step 3.1
Step 3.2

Step 4 e following steps are to instruct how to adjust the
hinges if needed.
4.1 Lateral adjustment by screw adjustment.
4.2 Front-to-Back by slackening and retightening the
hinge-arm mounting screw.
4.3 Vertical adjustment via slots on mounting plate by
slackening and retightening the screws on the
mounting plate.
Step 4.1 Step 4.2
Step 4.3